...
首页> 外文期刊>Applied optics >Optical sensors based on III-nitride photodetectors for flame sensing and combustion monitoring
【24h】

Optical sensors based on III-nitride photodetectors for flame sensing and combustion monitoring

机译:基于III族氮化物光电探测器的光学传感器,用于火焰感应和燃烧监控

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Combustion control requires visible photodetectors to sense the CH* CL emission at 430 nm that combined with a visible-blind UV photodetector allows us to obtain the OH*/CH* ratio. UV-visible P-InGaN/GaN multiple quantum well-N photodiodes with 15-18 mm~(2) areas were fabricated to conduct OH* (308 nm) and CH* CL detection without external filters. Bandpass detectors at 230-390 nm and 360-450 nm presented linear responses over five decades and rejection ratios >10~(3) at 430 and 308 nm, respectively. A full optical sensor system was built and detectors operated at 120 deg C in a combustion chamber, showing linear responses within the dynamic range, maximum signal-to-noise ratios of 10~(3) and response times of <1 s. An exponential association dependence between the optical OH*/CH* CL signals and the gas/air ratios was found.
机译:燃烧控制需要可见光检测器来感测430 nm处的CH * CL发射,再加上可见盲UV光电检测器,我们才能获得OH * / CH *比。制作了具有15-18 mm〜(2)面积的紫外可见P-InGaN / GaN多量子阱N光电二极管,无需外部过滤器即可进行OH *(308 nm)和CH * CL检测。 230-390 nm和360-450 nm的带通检测器在过去的几十年中呈现出线性响应,并且在430和308 nm处的抑制比分别> 10〜(3)。建立了一个完整的光学传感器系统,探测器在燃烧室中于120摄氏度下运行,显示出动态范围内的线性响应,最大信噪比为10〜(3)和响应时间<1 s。发现了光学OH * / CH * CL信号与气体/空气比率之间的指数相关性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号