...
首页> 外文期刊>Colloids and Surfaces, A. Physicochemical and Engineering Aspects >Interfacial shear rheology of asphaltenes at oil-water interface and its relation to emulsion stability: Influence of concentration, solvent aromaticity and nonionic surfactant
【24h】

Interfacial shear rheology of asphaltenes at oil-water interface and its relation to emulsion stability: Influence of concentration, solvent aromaticity and nonionic surfactant

机译:油水界面沥青质的界面剪切流变及其与乳液稳定性的关系:浓度,溶剂芳烃和非离子表面活性剂的影响

获取原文
获取原文并翻译 | 示例
           

摘要

The interfacial shear rheology of asphaltene film at toluene-heptane/brine interface has been studied. The oscillation mode of a rheometer utilizing a biconical geometry has been employed to determine film structure and mechanical strength of the interfacial layer, as a function of interface age, solvent aromaticity and asphaltene concentration. With 60% toluene-40% heptane as oil solvent, a concentration threshold around 2-5. g/L asphaltenes was found for the formation of gel-like structure at oil/brine interface, after aging for 6-7. h. This concentration is close to the concentration threshold for the formation of stable W/O emulsion. Further increase in concentration from 5 to 10. g/L gives similar interfacial modulus values, indicating that a saturation state of the interfacial layer is reached. At a given asphaltenes concentration 5. g/L, the storage modulus decreases when increasing the proportion of toluene and vanish with 100% toluene, however, much higher modulus was obtained for the same asphaltene concentration in 30% toluene which has flocculation inside. In addition, when nonionic surfactant coexist with asphaltenes in the bulk phase, only viscous interface was detected, which may attribute to the effect of surfactant for displacing asphaltenes at the interface and inhibiting asphaltene cluster formation in the bulk phase.
机译:研究了沥青质薄膜在甲苯-庚烷/盐水界面的界面剪切流变学。流变仪利用双锥几何形状的振荡模式已被用来确定界面层,溶剂芳族和沥青质浓度的函数的界面结构的膜结构和机械强度。以60%甲苯-40%庚烷为油溶剂,浓度阈值约为2-5。老化6-7次后,发现在油/盐水界面形成了g / L沥青质,形成了凝胶状结构。 H。该浓度接近于形成稳定的W / O乳液的浓度阈值。浓度从5进一步增加到10。g / L给出了相似的界面模量值,表明达到了界面层的饱和状态。在给定的沥青质浓度为5 g / L的情况下,当增加甲苯的比例时,储能模量会降低,并随100%的甲苯消失而消失,但是,在相同的沥青质浓度下,内部有絮凝的30%甲苯,其储能模量要高得多。另外,当非离子型表面活性剂与本体相中的沥青质共存时,仅检测到粘性界面,这可能归因于表面活性剂置换界面上的沥青质并抑制本体相中的沥青质团簇形成的作用。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号