...
首页> 外文期刊>Waste Management >Wet landfill decomposition rate determination using methane yield results for excavated waste samples
【24h】

Wet landfill decomposition rate determination using methane yield results for excavated waste samples

机译:使用甲烷产率结果对挖掘的废物样品进行湿填埋分解速率测定

获取原文
获取原文并翻译 | 示例
           

摘要

An increasing number of landfills are operated to accelerate waste decomposition through liquids addition (e.g., leachate recirculation) as a wet landfill. Landfill design and regulation often depend on utilizing landfill gas production models that require an estimate of a first-order gas generation rate constant, k. Consequently, several studies have estimated k using collected gas volumes from operating wet landfills. Research was conducted to examine an alternative approach in which k is estimated not from collected landfill gas but from solid waste samples collected over time and analyzed for remaining gas yield. To achieve this goal, waste samples were collected from 1990 through 2007 at two full-scale landfills in Florida that practiced liquids addition. Methane yields were measured from waste samples collected over time, including periods before and after leachate recirculation, and the results were applied to a firstorder decay model to estimate rate constants for each of the sites. An initial, intensive processing step was conducted to exclude non-biodegradable components from the methane yield testing procedure. The resulting rate constants for the two landfills examined were 0.47 yr~(-1) and 0.21 yr~(-1). These results expectedly exceeded the United States Environmental Protection Agency's rate constants for dry and conventional landfills (0.02-0.05 yr~'), but they are comparable to wet landfill rate constants derived using landfill gas data (0.1-0.3 yr~(-1)).
机译:越来越多的垃圾填埋场被用来通过添加液体(例如,渗滤液再循环)作为湿式垃圾填埋场来加速废物分解。垃圾填埋场的设计和法规通常取决于利用垃圾填埋气生产模型,该模型需要估算一阶气体产生速率常数k。因此,一些研究使用从湿润垃圾填埋场收集的气体量估算了k。进行了研究以检验一种替代方法,其中不是根据收集的垃圾填埋气估算k,而是根据随时间收集并分析剩余气体产量的固体废物样本估算k。为了实现这一目标,从1990年至2007年在佛罗里达州的两个满口垃圾填埋场收集了废物样本,这些垃圾填埋场实行了液体添加。从一段时间内收集的废物样品(包括渗滤液再循环之前和之后的时间)中测量甲烷的收率,并将结果应用于一阶衰减模型以估算每个站点的速率常数。进行了最初的密集处理步骤,以将不可生物降解的成分从甲烷产率测试程序中排除。所考察的两个垃圾填埋场的速率常数分别为0.47 yr〜(-1)和0.21 yr〜(-1)。这些结果有望超过美国环境保护署的干式和常规垃圾填埋场的速率常数(0.02-0.05 yr〜'),但与使用垃圾填埋场气体数据得出的湿式垃圾填埋率常数(0.1-0.3 yr〜(-1))相当。 )。

著录项

  • 来源
    《Waste Management》 |2012年第7期|p.1427-1433|共7页
  • 作者单位

    Department of Environmental Engineering Sciences, University of Florida, P.O. Box 116450, Gainesville, FL 32611, USA,Department of Environmental Science and Engineering, Cannon University, 109 University Square, Erie, PA 16541, USA;

    Department of Environmental Engineering Sciences, University of Florida, P.O. Box 116450, Gainesville, FL 32611, USA;

  • 收录信息
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    landfill; landfill gas; solid waste; methane; waste decomposition; bioreactor landfill;

    机译:垃圾填埋场;垃圾填埋气;固体垃圾;甲烷废物分解;生物反应堆填埋场;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号