Standard Specification for MRS-Rated Metric- and Inch-Sized Crosslinked Polyethylene (PEX) Pressure Pipe for Gas Distribution Applications

摘要

1.1This specification covers crosslinked polyethylene (PEX) pipe that is outside diameter controlled in metric pipe sizes (DN 16 to 1000) and inch pipe sizes (NPS 3 to 54), and pressure rated (seeAppendix X1) using the MRS rating system. This Specification is intended for PEX pipe made by various processes, as long as the PEX pipe made by that process meets all the requirements of this Specification. Included are requirements and test methods for material, workmanship, UV protection, dimensions, hydrostatic sustained pressure, stabilizer functionality, bent-pipe hydrostatic pressure, chemical resistance, minimum operating temperature, degree of crosslinking, squeeze-off, and hydrostatic burst pressure. Requirements for pipe markings are also given. The pipe covered by this specification is intended for natural gas distribution.1.2This specification also includes requirements for qualifying joints made using polyethylene electrofusion fittings (such as SpecificationF3373) and PEX pipe. Fittings to be used with PEX pipe manufactured to this specification are in SpecificationF2829/F2829M. Installation considerations are inX3.2.Note 1:NPS fittings should not be used for DN sized pipe, and DN sized fittings should not be used for NPS pipe.1.3The text of this specification references notes, footnotes, and appendixes, which provide explanatory material. These notes and footnotes (excluding those in tables and figures) should not be considered as requirements of the specification.1.4Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.1.4.1For consistency with ISO 9080, MRS values are only in MPa and degrees Centigrade for conversion to the pipe material designation code (for example PEX pipe with an MRS of 8 MPa is called a PEX 80.1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.