Standard Specification for Welded Austenitic Steel Boiler, Superheater, Heat-Exchanger, and Condenser Tubes

摘要

1.1This specification2covers nominal-wall-thickness welded tubes and heavily cold worked welded tubes made from the austenitic steels listed inTable 1, with various grades intended for such use as boiler, superheater, heat exchanger, or condenser tubes.1.2Grades TP304H, TP309H, TP309HCb, TP310H, TP310HCb, TP316H, TP321H, TP347H, and TP348H are modifications of Grades TP304, TP309S, TP309Cb, TP310S, TP310Cb, TP316, TP321, TP347, and TP348, and are intended for high-temperature service such as for superheaters and reheaters.1.3The tubing sizes and thicknesses usually furnished to this specification are1/8in. [3.2 mm] in inside diameter to 12 in. [304.8 mm] in outside diameter and 0.015 to 0.320 in. [0.4 to 8.1 mm], inclusive, in wall thickness. Tubing having other dimensions may be furnished, provided such tubes comply with all other requirements of this specification.1.4Mechanical property requirements do not apply to tubing smaller than1/8in. [3.2 mm] in inside diameter or 0.015 in. [0.4 mm] in thickness.1.5Optional supplementary requirements are provided and, when one or more of these are desired, each shall be so stated in the order.1.6The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. The inch-pound units shall apply unless the “M” designation of this specification is specified in the order.1.7The following safety hazards caveat pertains only to the test method described in the Supplementary Requirements of this specification.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.A specific warning statement is given in Supplementary Requirement S7, Note S7.1.