首页> 外文OA文献 >Swelling-induced structural changes and microparticle uptake of gelatin gels probed by NMR and CLSM
【2h】

Swelling-induced structural changes and microparticle uptake of gelatin gels probed by NMR and CLSM

机译:通过NmR和CLsm探测溶胀诱导的结构变化和明胶凝胶的微粒摄取

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Gelatin gels are increasingly involved in many industrial applications due to several advantages including cost efficiency and biocompatibility. Generally, their production requires the use of aqueous solvents, which cause significant swelling, due to the ability of solvent molecules to penetrate through the gel microstructure and increase its volume. Since swelling mechanisms and their effect on the gel structure are not fully understood, further investigations are required. In this work, we combine macroscopic measurements of the swelling ratio (SR) with Nuclear Magnetic Resonance (NMR) and Confocal Laser Scanning Microscopy (CLSM) to investigate changes in the gelatin structure as a function of both polymer concentration and swelling time. SR values increase as a function of time until a maximum is reached and then show a slight drop for all the gelatin concentrations after 24 h swelling time, probably due to a network relaxation process. NMR allows determination of mass transport and molecular dynamics of water inside the gelatin pores, while CLSM is used to visualize the penetration of tracers (polystyrene microbeads) with a diameter much larger than the gel pores. Structural parameters, such as average pore size and tortuosity, are estimated. In particular, the pore size decreases for higher polymer concentration and increases during swelling, until reaching a maximum, and then dropping at longer times. The penetration of tracers provides evidence of the heterogeneity of the gel structure and shows that single microcarriers can be loaded in gelatin gels upon swelling.
机译:明胶凝胶由于包括成本效率和生物相容性在内的若干优点而越来越多地参与许多工业应用。通常,由于溶剂分子穿透凝胶微结构并增加其体积的能力,它们的生产需要使用水性溶剂,这会引起明显的溶胀。由于尚未完全了解溶胀机理及其对凝胶结构的影响,因此需要进一步研究。在这项工作中,我们将溶胀率(SR)的宏观测量结果与核磁共振(NMR)和共聚焦激光扫描显微镜(CLSM)结合起来,以研究明胶结构随聚合物浓度和溶胀时间的变化。 SR值随时间的增加而增加,直到达到最大值,然后在24小时溶胀时间后所有明胶浓度均显示出轻微下降,这可能是由于网络松弛过程所致。 NMR可以确定明胶孔中水的质量传递和分子动力学,而CLSM用于可视化直径比凝胶孔大得多的示踪剂(聚苯乙烯微珠)的渗透。估计结构参数,例如平均孔径和曲折度。尤其是,孔径随着较高的聚合物浓度而减小,并在溶胀期间增大,直到达到最大值,然后在更长的时间内下降。示踪剂的渗透提供了凝胶结构异质性的证据,并表明在溶胀后,单个微载体可以装载在明胶中。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号