The median-times-to-failure (t₅₀’s) for straight dual-damascene via-terminated copper interconnect structures, tested under the same conditions, depend on whether the vias connect down to underlaying leads (metal 2, M2, or via-below structures) or connect up to overlaying leads (metal 1, M1, or via-above structures). Experimental results for a variety of line lengths, widths, and numbers of vias show higher t₅₀’s for M2 structures than for analogous M1 structures. It has been shown that despite this asymmetry in lifetimes, the electromigration drift velocity is the same for these two types of structures, suggesting that fatal void volumes are different in these two cases. A numerical simulation tool based on the Korhonen model has been developed and used to simulate the conditions for void growth and correlate fatal void sizes with lifetimes. These simulations suggest that the average fatal void size for M2 structures is more than twice the size of that of M1 structures. This result supports an earlier suggestion that preferential nucleation at the Cu/Si₃N₄ interface in both M1 and M2 structures leads to different fatal void sizes, because larger voids are required to span the line thickness in M2 structures while smaller voids at the base of vias can cause failures in M1 structures. However, it is also found that the fatal void sizes corresponding to the shortest-times-to-failure (STTF’s) are similar for M1 and M2, suggesting that the voids that lead to the shortest lifetimes occur at or in the vias in both cases, where a void need only span the via to cause failure. Correlation of lifetimes and critical void volumes provides a useful tool for distinguishing failure mechanisms.
展开▼
