首页> 外文OA文献 >Sample size requirements to estimate key design parameters from external pilot randomised controlled trials: a simulation study
【2h】

Sample size requirements to estimate key design parameters from external pilot randomised controlled trials: a simulation study

机译:通过外部试点随机对照试验估算关键设计参数的样本量要求:模拟研究

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Background: External pilot or feasibility studies can be used to estimate key unknown parameters to inform the design of the definitive randomised controlled trial (RCT). However, there is little consensus on how large pilot studies need to be, and some suggest inflating estimates to adjust for the lack of precision when planning the definitive RCT.Methods: We use a simulation approach to illustrate the sampling distribution of the standard deviation for continuous outcomes and the event rate for binary outcomes. We present the impact of increasing the pilot sample size on the precision and bias of these estimates, and predicted power under three realistic scenarios. We also illustrate the consequences of using a confidence interval argument to inflate estimates so the required power is achieved with a pre-specified level of confidence. We limit our attention to external pilot and feasibility studies prior to a two-parallel-balanced-group superiority RCT.Results: For normally distributed outcomes, the relative gain in precision of the pooled standard deviation (SD) is less than 10% (for each five subjects added per group) once the total sample size is 70. For true proportions between 0.1 and 0.5, we find the gain in precision for each five subjects added to the pilot sample is less than 5% once the sample size is 60. Adjusting the required sample sizes for the imprecision in the pilot study estimates can result in excessively large definitive RCTs and also requires a pilot sample size of 60 to 90 for the true effect sizes considered here.Conclusions: We recommend that an external pilot study has at least 70 measured subjects (35 per group) when estimating the SD for a continuous outcome. If the event rate in an intervention group needs to be estimated by the pilot then a total of 60 to 100 subjects is required. Hence if the primary outcome is binary a total of at least 120 subjects (60 in each group) may be required in the pilot trial. It is very much more efficient to use a larger pilot study, than to guard against the lack of precision by using inflated estimates. © 2014 Teare et al.; licensee BioMed Central Ltd.
机译:背景:外部试验或可行性研究可用于估算关键的未知参数,从而为确定性随机对照试验(RCT)的设计提供依据。但是,对于需要进行多少规模的试点研究尚无共识,有人建议在规划确定的RCT时夸大估计以弥补精度不足的方法。方法:我们使用一种模拟方法来说明标准偏差的抽样分布。连续结果和二进制结果的事件发生率。我们介绍了在三种实际情况下,增加试点样本数量对这些估计的精度和偏差以及预测功效的影响。我们还将说明使用置信区间参数对估计值进行膨胀的结果,以便以预先指定的置信度获得所需的功效。我们将注意力集中在外部平行试验和可行性研究之前,而不是采用两个平行平衡组的优势RCT。结果:对于正态分布的结果,合并标准偏差(SD)的精度相对增益小于10%(对于如果总样本量为70,则每组增加五个主题。对于真实比例在0.1到0.5之间的样本,一旦样本大小为60,我们发现添加到中试样本的每五个主题的精度增益小于5%。调整初步研究估计中不精确性所需的样本量可能会导致确定的随机对照试验过大,并且对于此处考虑的真实效应量,还需要60到90的初步样本量。结论:我们建议外部初步研究应采用估计连续结果的SD时,至少有70名被测者(每组35名)。如果飞行员需要估计干预组中的事件发生率,则总共需要60至100名受试者。因此,如果主要结果是二进制的,那么在试验试验中可能至少需要120位受试者(每组60位)。使用较大的先导研究比使用夸大的估计来防止缺乏精确性要有效得多。 ©2014 Teare等;被许可人BioMed Central Ltd.

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号