首页> 外文OA文献 >Synthesis and structural studies of NiS and PdS nanoparticles/nanocomposites from dithiocarbamates single source precursors
【2h】

Synthesis and structural studies of NiS and PdS nanoparticles/nanocomposites from dithiocarbamates single source precursors

机译:二硫代氨基甲酸酯单源前体Nis和pds纳米粒子/纳米复合材料的合成与结构研究

摘要

The main aim of this research is to synthesize Ni(II) and Pd(II) dithiocarbamate complexes and use them as single source precursors for the synthesis of NiS and PdS nanoparticles and metal sulphides potato starch nanocomposites. Four dithiocarbamate ligands were synthesized and characterized using elemental analysis and spectroscopic techniques. The ligands were used to prepared homoleptic Ni(II) and Pd(II) complexes of the dithiocarbamate ligands. The metal complexes were characterized with elemental analysis, UV-Vis, FTIR and 1H-NMR spectroscopic techniques. Conductivity measurements indicate that all the complexes are non-electrolytes in solution and results from the electronic spectra studies confirmed the proposed 4-coordinate square planar geometry around the metal ions. The nickel complexes showed d-d transitions around 477 nm while in the palladium complexes, no d-d transitions were observed but the compounds showed strong metal to ligand charge transfer transitions. From the FTIR spectra studies, it can be confirmed that the complexes were successfully synthesised because all peaks of interest were observed at expected regions from the literature. The νC-N was observed around 1469-1495 cm-1, νC=S around 1101-1188 cm-1 and νC-S around 738-1060 cm-1 for both Ni(II) and Pd(II) complexes. νNi-S was observed around 375-543 cm-1 and νPd-S around 529-545 cm-1. The FTIR also confirmed that the dithiocarbamate ligands act as bidentate chelating ligands through the sulfur atoms. The complexes were used as single source precursors and thermolysed in hexadecylamine (HDA) at 220 °C to prepare four HDA-capped nickel sulfide nanoparticles and four palladium sulfide nanoparticles. The as-prepared nanoparticles were studied with optical absorption spectra, photoluminescence, powder X-ray diffraction (PXRD), transmission electron microscopy (TEM), scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDS). The optical studies results showed that NiS have large band gaps that are greater than that of the bulk, therefore they are found to be blue shifted relative to the bulk, which shows that they have small particle size and thus confirming their quantum confinement effect. PL spectra reveal that the emission peaks are red shifted compared to the absorption band edges of the nanoparticles. The XRD patterns confirmed the formation of cubic and rhombohedral phase for NiS nanoparticles and cubic phase for PdS nanoparticles. SEM images of both NiS and PdS show uniform surface morphology at low and high magnification with different shapes. EDS analyses confirmed the presence of Ni, S, and Pd in each of the spectrum indicating that the nanoparticles were successfully synthesized. TEM images showed that the synthesised nanoparticles have uniform and narrow size distribution with no agglomeration. The sizes of the NiS nanoparticles were found to be in the range of 12-38 nm for NiS1, 8-11 nm for NiS2, 9-16 nm for NiS3 and 4-9 nm for NiS4. The TEM images for the as-prepared PdS nanoparticles showed that the average crystallite sizes are 6.94-9.62 nm for PdS1, 8-11 nm for PdS2, 9-16 nm for PdS3 and 4-9 nm for PdS4 respectively. The nanoparticles were used to prepare potato starch nanocomposites and SEM images indicate that the surface morphology of starch polymer nanocomposites compose of potato starch and few particles in between the pores of the matrix, this is due to the small ratio of nanoparticles used.
机译:这项研究的主要目的是合成Ni(II)和Pd(II)二硫代氨基甲酸酯配合物,并将其用作合成NiS和PdS纳米粒子以及金属硫化物马铃薯淀粉纳米复合材料的单一来源前体。合成了四种二硫代氨基甲酸酯配体,并使用元素分析和光谱技术对其进行了表征。配体用于制备二硫代氨基甲酸酯配体的均相Ni(II)和Pd(II)配合物。通过元素分析,UV-Vis,FTIR和1H-NMR光谱技术对金属配合物进行了表征。电导率测量表明,所有络合物在溶液中均为非电解质,电子光谱研究的结果证实了拟议的围绕金属离子的4坐标方平面几何形状。镍络合物在477 nm附近显示d-d跃迁,而在钯络合物中,未观察到d-d跃迁,但化合物显示出很强的金属到配体电荷转移跃迁。从FTIR光谱研究中可以确认,由于在文献中的预期区域观察到了所有感兴趣的峰,因此复合物得以成功合成。对于Ni(II)和Pd(II)配合物,在1469-1495 cm-1附近观察到νC-N,在1101-1188 cm-1附近观察到νC= S,在738-1060 cm-1附近观察到νC-S。在375-543 cm-1附近观察到νNi-S,在529-545 cm-1附近观察到νPd-S。 FTIR还证实二硫代氨基甲酸酯配体通过硫原子充当二齿螯合配体。将该配合物用作单一来源的前体,并在220℃的十六烷基胺(HDA)中加热,以制备四个HDA封端的硫化镍纳米粒子和四个硫化钯纳米粒子。使用光吸收光谱,光致发光,粉末X射线衍射(PXRD),透射电子显微镜(TEM),扫描电子显微镜(SEM)和能量色散X射线光谱(EDS)研究了制备的纳米颗粒。光学研究结果表明,NiS具有比本体更大的大带隙,因此发现它们相对于本体发生蓝移,这表明它们具有较小的粒径,从而证实了其量子限制效应。 PL光谱显示,与纳米粒子的吸收带边缘相比,发射峰发生了红移。 XRD图谱证实了NiS纳米颗粒的立方相和菱面体相以及PdS纳米颗粒的立方相。 NiS和PdS的SEM图像在低倍率和高倍率下均显示出具有不同形状的均匀表面形态。 EDS分析证实在每个光谱中均存在Ni,S和Pd,表明纳米粒子已成功合成。 TEM图像表明,所合成的纳米颗粒具有均匀且窄的尺寸分布,没有团聚。发现NiS纳米颗粒的尺寸对于NiS1为12-38nm,对于NiS2为8-11nm,对于NiS3为9-16nm,对于NiS4为4-9nm。制备的PdS纳米颗粒的TEM图像显示,PdS1的平均微晶尺寸为6.94-9.62 nm,PdS2的平均微晶尺寸为8-11 nm,PdS3的平均微晶尺寸为9-16 nm,PdS4的平均微晶尺寸为4-9 nm。该纳米颗粒用于制备马铃薯淀粉纳米复合材料,SEM图像表明,淀粉聚合物纳米复合材料的表面形态由马铃薯淀粉组成,基质孔之间的颗粒很少,这是由于所用纳米颗粒的比例较小。

著录项

  • 作者

    Nqombolo Azile;

  • 作者单位
  • 年度 2016
  • 总页数
  • 原文格式 PDF
  • 正文语种 English
  • 中图分类

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号