The purpose of preparing this final project was to determine 1) the types of machinery and equipment used in the manufacturing process of input funnel, chopper shaft lid, and output funnel 2) the equipment needed to fulfill safety manufacturing process, 3) the sequence process, 4) the time required in the manufacturing process; 5) the costs in making funnel, chopper shaft lid, and output funnel 6) performance when the machine is operated.udThe methods used in the manufacturing of input funnel, chopper shaft lid, and output funnel are the working plan identification, the material identification, the selection of machinery and equipment used, and the determination of work processes to be used. While the process stages include preparation of materials, paint materials, the cutting process, the formation process, and the surface finish. The material used is eyzer plate with a thickness of 1.2 mm. Machineries and equipments used are hydrolic JORG plate cutting machine type 40662, Edwards Truefold manual bending machine, plate rolling machine BSR/2/45, Hitachi drilling machine, SMAW welding machine brands OTC KR 400, a compressor and spray gun, steel ruler, roll feet, elbows ruler, protractor, etcher, pointer, plate shears, caliper, hand drill machine BOSCH 65B 20-2, miserly, anvil and hammer.udThe time required based on real-time process is approximately 987 minutes or 16 hours and 45 minutes. Performance test on fodder chopping machine is able to chop 1.5 kg fodder in 1 minute. Input funnel, chopper shaft lid, and output funnel are able to withstand the fodder so it will not be scattered.ud
展开▼
