首页> 外文OA文献 >A new buffering design concept for Voice Over Internet Protocol (VOIP)
【2h】

A new buffering design concept for Voice Over Internet Protocol (VOIP)

机译:Internet语音协议(VOIP)的新缓冲设计概念

摘要

Priority Queuing (PQ) algorithm is a more popular technique which used in the VoIP network to reduce delays. In the PQ algorithm there are four buffering packet are low, normal, medium and high. The buffering packet in PQ algorithm is greedy. However, fourth the buffering is not optimal used. It is caused by PQ algorithm is based on the priority, whereas this buffering just always serviced is highest priority. While under priority are rarely or never serviced will cause other buffering rarely used. While SPBA algorithm is architecture easiest and it does not need any resource reservation or threshold dropping, but only makes use of priority scheduling. On the SPBA algorithm, where incoming packets are placed into the two priority traffic classes is high class and low class. On the SPBA algorithm is there are not available reservation sources to save the remaining packets when the explosion (burst) traffic occurred, which could impact to packet drop and packet loss. Then, with the efficiency of PQ buffering algorithm, can provide greater impact to reduce delays. This paper showed a new buffer design to simplify two concepts buffer in the PQ algorithm and SPBA algorithm. In the new buffering algorithm, simplify four buffering into three packets (High, Medium and Low) is proposed. In the new buffering algorithm able to handle, solve problems and weaknesses of both algorithms. The new buffering design is expected to provide a better solution for the packet buffering. In the new buffering algorithm, greedy packet buffering does not occur as the PQ algorithm and then discard packets, dropped packets, and packet loss does not happen again like as occurred in the SPBA algorithm.
机译:优先队列(PQ)算法是一种更流行的技术,用于VoIP网络中以减少延迟。在PQ算法中,有四个缓冲数据包:低,正常,中和高。 PQ算法中的缓冲数据包是贪婪的。然而,第四,缓冲不是最佳使用。它是由基于优先级的PQ算法引起的,而这种始终保持服务状态的缓冲是最高优先级。在优先级下很少或永远不会提供服务会导致很少使用其他缓冲。尽管SPBA算法是最简单的体系结构,并且不需要任何资源预留或阈值降低,但仅利用优先级调度。在SPBA算法中,将进入的数据包放置在两个优先级流量类别中的是高类别和低类别。在SPBA算法上,当发生爆炸(突发)流量时,没有可用的保留源来保存剩余的数据包,这可能会影响数据包丢失和数据包丢失。然后,借助PQ缓冲算法的效率,可以提供更大的影响以减少延迟。本文展示了一种新的缓冲区设计,简化了PQ算法和SPBA算法中两个概念的缓冲区。在新的缓冲算法中,提议将四个缓冲简化为三个数据包(高,中和低)。在新的缓冲算法中能够处理,解决两种算法的问题和弱点。新的缓冲设计有望为数据包缓冲提供更好的解决方案。在新的缓冲算法中,贪婪的数据包缓冲不会像PQ算法那样发生,然后会丢弃数据包,丢弃的数据包,并且不会再发生像SPBA算法中那样的数据包丢失。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号