首页> 外文OA文献 >The development of adsorbent based natural gas storage for vehicle application
【2h】

The development of adsorbent based natural gas storage for vehicle application

机译:基于吸附剂的汽车用天然气储存器的开发

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Storage of natural gas by adsorption has a potential to replace Compressed Natural Gas (CNG) in mobile storage applications, such as in vehicles. Storage by adsorption at moderate pressure of 500 psig could be expected to reduce the problem of bulky high-pressure CNG storage within a confined space used in vehicle. In adsorptive storage, the amount of gas stored at lower pressure increases when a large portion of gas adsorbs on the adsorbent. However, its capacity and performance depend on adsorbent types and properties. This study is focused on the storage capacity and delivery performance of Adsorptive Natural Gas (ANG) storage employing different types of commercial adsorbents which were carried out by performing experimental work on an ANG storage system. Methane adsorptive storage was done in a 0.5-liter adsorbent-filled gas vessel under isothermal and dynamic conditions. The ANG vessel was charged with methane up to 500 psig at different rates of filling and was discharged under dynamic condition at a varied rate of discharge. The results show that the storage capacity obtained under isothermal condition is higher than under dynamic condition due to continuous temperature rise experienced during dynamic charging. Higher storage capacities were obtained for adsorbent with larger surface area and micropore volume but smaller interparticle void. Adsorbent that has high heat capacity and low heat of methane adsorption yields lesser temperature rise during adsorption and lesser temperature fall during desorption. Consequently, these characteristics lead to a better storage and delivery capacities. At faster charging rate, lower storage capacity was obtained and faster discharging rate caused inefficient gas delivery. Under cyclic operation, adsorbents performances deteriorate when adsorbent structure is gradually damaged under high-pressure operation. Among the adsorbents tested, palm shell activated carbon shows the highest storage and delivery capacity which are 87.4 V/V and 75.8 V/V respectively.
机译:通过吸附来存储天然气有潜力在移动存储应用(例如车辆)中替代压缩天然气(CNG)。可以预期通过在500 psig的中等压力下吸附来存储,以减少在车辆所用的密闭空间内庞大的高压CNG存储问题。在吸附存储中,当大部分气体吸附在吸附剂上时,在较低压力下存储的气体量增加。但是,其容量和性能取决于吸附剂的类型和性质。这项研究的重点是采用不同类型的商业吸附剂的吸附式天然气(ANG)储存器的储存容量和输送性能,这些吸附剂是通过在ANG储存系统上进行实验工作而进行的。甲烷吸附性储存是在等温和动态条件下于0.5升充满吸附剂的气体容器中进行的。 ANG容器以不同的填充速率充入高达500 psig的甲烷,并在动态条件下以变化的排放速率排放。结果表明,由于动态充电过程中温度不断升高,等温条件下获得的存储容量高于动态条件下的存储容量。对于具有较大的表面积和微孔体积但较小的颗粒间空隙的吸附剂,可以获得较高的存储容量。具有高热容量和低甲烷吸附热的吸附剂在吸附过程中产生较少的温度升高,而在解吸过程中产生较小的温度下降。因此,这些特征导致更好的存储和传送能力。在更快的充电速率下,可获得较低的存储容量,而更快的放电速率会导致气体输送效率低下。在循环操作下,当在高压操作下吸附剂结构逐渐损坏时,吸附剂性能下降。在测试的吸附剂中,棕榈壳活性炭显示出最高的储存和输送容量,分别为87.4 V / V和75.8 V / V。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号