首页> 外文OA文献 >Cation exchange membranes by radiation-induced graft copolymerization of styrene onto PFA copolymer films. I. preparation and characterization of the graft copolymer
【2h】

Cation exchange membranes by radiation-induced graft copolymerization of styrene onto PFA copolymer films. I. preparation and characterization of the graft copolymer

机译:通过辐射诱导苯乙烯在PFA共聚物薄膜上的接枝共聚反应制成阳离子交换膜。一,接枝共聚物的制备与表征

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

PFA-g-polystyrene graft copolymers were prepared by simultaneous radiation- induced graft copolymerization of styrene onto poly(tetrafluoroethylene-co-perfluorovinyl ether) (PFA) films. The effects of grafting conditions such as monomer concentration, dose, and dose rate were investigated. Three solvents, i.e., methanol, benzene, and dichloromethane, were used as diluents in this grafting system. Of the three solvents employed, dichloromethane was found to greatly enhance the grafting process, and the degree of grafting increased with the increase of monomer concentration until it reached its highest value at a styrene concentration of 60 (vol %). The dependence of the initial rate of grafting on the monomer concentration was found to be of the order of 1.2. The degree of grafting was found to increase with the increase in irradiation dose, while it considerably decreased with the increase in dose rate. The formation of graft copolymers was confirmed by FTIR analysis. The structural investigation by X-ray diffraction (XRD) shows that the degree of crystallinity content of such graft copolymers decreases with the increase in grafting, and consequently, the mechanical properties of the graft copolymers were influenced to some extent. Both tensile strength and elongation percent decreased with the increase in the degree of grafting.
机译:PFA-g-聚苯乙烯接枝共聚物是通过将苯乙烯同时辐射诱导接枝共聚到聚(四氟乙烯-全氟乙烯基醚)(PFA)薄膜上而制得的。研究了接枝条件如单体浓度,剂量和剂量率的影响。在该接枝体系中,使用了三种溶剂,即甲醇,苯和二氯甲烷作为稀释剂。在使用的三种溶剂中,发现二氯甲烷可大大促进接枝过程,并且接枝程度随单体浓度的增加而增加,直到在苯乙烯浓度为60(体积%)时达到最高值为止。发现接枝起始速率对单体浓度的依赖性约为1.2。发现接枝度随辐照剂量的增加而增加,而随剂量率的增加而显着降低。通过FTIR分析证实了接枝共聚物的形成。 X射线衍射(XRD)的结构研究表明,这种接枝共聚物的结晶度随接枝的增加而降低,因此,对接枝共聚物的机械性能有一定的影响。随着接枝度的增加,抗张强度和伸长率均降低。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号