首页> 外文OA文献 >Energy Conversion From Woody Biomass Stuff: Possible Manufacture of Briquetted Charcoal From Sawmill-generated Sawdust
【2h】

Energy Conversion From Woody Biomass Stuff: Possible Manufacture of Briquetted Charcoal From Sawmill-generated Sawdust

机译:木质生物质原料的能量转化:可能由锯木厂产生的木屑生产压块木炭

摘要

There are three dominant kinds of wood industries in Indonesia which consume huge amount of wood materials as well as generate considerable amount of woody waste stuffs, i.e. sawmills, plywood, and pulp/paper. For the two latest industries, their wastes to great extent have been reutilized in the remanufacturing process, or burnt under controlled condition to supplement their energy needs in the corresponding factories, thereby greatly alleviating environmental negative impacts. However, wastes from sawmills (especially sawdust) still often pose a serious environmental threat, since they as of this occasion are merely dumped on sites, discarded to the stream, or merely burnt, hence inflicting dreadful stream as well as air pollutions. One way to remedy those inconveniences is by converting the sawdust into useful product, i.e. briquetted charcoal, as has been experimentally tried. The charcoal was at first prepared by carbonizing the sawdust wastes containing a mixture of the ones altogether from the sawing of seven particular Indonesia\u27s wood species, and afterwards was shaped into the briquette employing various concentrations of starch binder at two levels (3.0 and 5.0 %) and also various hydraulic pressures (1.0, 2.5, and 5.0 kg/cm2). Further, the effect of those variations was examined on the yield and qualities of the resulting briquetted charcoal.The results revealed that the most satisfactory yield and qualities of the briquetted sawdustcharcoal were acquired at 3 % starch binder concentration with 5.0 kg/cm2 hydraulic pressure. As such, the briquette qualities were as follows: density at 0.60 gram/cm3, tensile strength 15.27 kg/cm2, moisture content 2.58 %, volatile matter 23.35 %, ash content 4.10 %, fixed carbon 72.55 %, and calorific value 5,426 cal/gram. Those qualities revealed that the experimented briquetted sawdust charcoal could be conveniently used as biomass-derived fuel.
机译:印度尼西亚有三种主要的木材工业,它们消耗大量的木材原料并产生大量的木屑废物,即锯木厂,胶合板和纸浆/纸。对于这两个最新行业,它们的废物在再制造过程中已被大量再利用,或在受控条件下燃烧以补充相应工厂中的能源需求,从而大大减轻了对环境的负面影响。然而,来自锯木厂的废物(尤其是锯末)仍然经常构成严重的环境威胁,因为此时它们仅被倾倒在现场,丢弃到溪流中或仅被燃烧,从而造成了可怕的溪流以及空气污染。补救这些不便的一种方法是将木屑转化为有用的产品,即压成块状的木炭,这已经通过实验进行了尝试。木炭首先是通过将锯木屑的碳化物碳化而得到的,这些木屑屑包含了锯切7种特定印尼木材物种的混合物,然后使用各种浓度的淀粉粘合剂以两种水平(3.0和5.0)将其成型为团块。 %)以及各种液压压力(1.0、2.5和5.0 kg / cm2)。此外,研究了这些变化对所得压块木炭的产量和质量的影响。结果表明,在5.0 kg / cm2的液压压力下,淀粉粘合剂浓度为3%时,可获得压块的锯末木炭的最令人满意的产量和质量。这样,煤饼质量如下:密度为0.60克/立方厘米,抗张强度为15.27千克/平方厘米,水分为2.58%,挥发物为23.35%,灰分为4.10%,固定碳为72.55%,发热量为5,426卡/公克。这些性质表明,实验性的团块状木屑木炭可以方便地用作生物质来源的燃料。

著录项

  • 作者

    Roliadi, Han; Pari, Gustan;

  • 作者单位
  • 年度 2006
  • 总页数
  • 原文格式 PDF
  • 正文语种 EN
  • 中图分类
  • 入库时间 2022-08-20 20:53:39

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号