首页> 外文OA文献 >Fluence-dependent formation of Zn and ZnO nanoparticles by ion implantation and thermal oxidation: An attempt to control nanoparticle size
【2h】

Fluence-dependent formation of Zn and ZnO nanoparticles by ion implantation and thermal oxidation: An attempt to control nanoparticle size

机译:通过离子注入和热氧化形成依赖注量的Zn和ZnO纳米粒子:控制纳米粒子尺寸的尝试

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。
获取外文期刊封面目录资料

摘要

For possible control of the size of nanoparticles (NPs), the fluence-dependent formation of Zn and ZnO NPs by ion implantation with and without thermal oxidation was investigated by optical absorption spectroscopy, Rutherford backscattering spectrometry, and small-angle x-ray scattering (SAXS). The mean diameter and number density of Zn NPs in the as-implanted state in silica (SiO2) were determined by SAXS as 7 nm and 13 X 10(17) cm(-3), 12 nm and 3.8 X 10(17) cm(-3), and 12 nm and 3.2 X 10(17) cm(-3) for fluences of 0.50, 1.0, and 2.0 X 10(17) ions/cm(2), respectively. With increasing fluence, the mean diameter of the NPs increases and the number density decreases. However, an upper limit of the NP size and Zn concentration in SiO2 is observed above the fluence of 1.0 X 10(17) ions/cm(2) due to sputtering loss. Thermal annealing in oxygen gas at 700 degrees C for 1 h induces the transformation of Zn NPs to both ZnO NPs and the Zn2SiO4 phase. With decreasing fluence, the branching ratio to the ZnO component decreases. This is because the reaction between tentatively formed ZnO NPs and the SiO2 substrate is enhanced by the higher surface-to-volume ratio of smaller NPs. At a fluence of 0.20 X 10(17) ions/cm(2), almost no ZnO component was detected. The size control of Zn and ZnO NPs is therefore possible only in a limited fluence region. (C) 2008 American Institute of Physics. [DOI: 10.1063/1.3014032]
机译:为了可能控制纳米颗粒(NPs)的大小,通过光学吸收光谱,卢瑟福背散射光谱和小角度X射线散射( SAXS)。通过SAXS确定在二氧化硅(SiO2)中处于植入状态的Zn NP的平均直径和数量密度分别为7 nm和13 X 10(17)cm(-3),12 nm和3.8 X 10(17)cm (-3),12 nm和3.2 X 10(17)cm(-3)分别用于0.50、1.0和2.0 X 10(17)离子/ cm(2)的注量。随着通量的增加,NP的平均直径增加并且数目密度降低。但是,由于溅射损失,在1.0 X 10(17)离子/ cm(2)的注量以上,观察到SiO2中NP尺寸和Zn浓度的上限。在氧气中于700摄氏度下进行热退火1 h会诱导Zn NPs转变为ZnO NPs和Zn2SiO4相。随着通量的降低,对ZnO组分的支化比降低。这是因为通过较小的NP的较高的表面积/体积比,可以加快暂定形成的ZnO NP与SiO2衬底之间的反应。在0.20 X 10(17)离子/ cm(2)的注量下,几乎没有检测到ZnO组分。因此,仅在有限的注量范围内才可以控制Zn和ZnO NP的尺寸。 (C)2008美国物理研究所。 [DOI:10.1063 / 1.3014032]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号