首页> 外文OA文献 >Iterative receivers and multichannel equalisation for time division multiple access systems
【2h】

Iterative receivers and multichannel equalisation for time division multiple access systems

机译:时分多址系统的迭代接收机和多通道均衡

摘要

The thesis introduces receiver algorithms improving the performance of TDMA mobile radio systems. Particularly, we consider receivers utilising side information, which can be obtained from the error control coding or by having a priori knowledge of interference sources. Iterative methods can be applied in the former case and interference suppression techniques in the latter.Convolutional coding adds redundant information into the signal and thereby protects messages transmitted over a radio channel. In the coded systems the receiver is usually comprised of separate channel estimation, detection and channel decoding tasks due to complexity restrictions. This suboptimal solution suffers from performance degradation compared to the optimal solution achieved by optimising the joint probability of information bits, transmitted symbols and channel impulse response. Conventional receiver utilises estimated channel state information in the detection and detected symbols in the channel decoding to finally obtain information bits. However, the channel decoder provides also extrinsic information on the bit probabilities, which is independent of the received information at the equaliser input. Therefore it is beneficial to re-perform channel estimation and detection using this new extrinsic information together with the original input signal.We apply iterative receiver techniques mainly to Enhanced General Packet Radio System (EGPRS) using GMSK modulation for iterative channel estimation and 8-PSK modulation for iterative detection scheme. Typical gain for iterative detection is around 2 dB and for iterative channel estimation around 1 dB. Furthermore, we suggest two iteration rounds as a reasonable complexity/performance trade-off. To obtain further complexity reduction we introduce the soft trellis decoding technique that reduces the decoder complexity significantly in the iterative schemes.Cochannel interference (CCI) originates from the nearby cells that are reusing the same transmission frequency. In this thesis we consider CCI suppression by joint detection (JD) technique, which detects simultaneously desired and interfering signals. Because of the complexity limitations we only consider JD for two binary modulated signals. Therefore it is important to find the dominant interfering signal (DI) to achieve the best performance. In the presence of one strong DI, the JD provides major improvement in the receiver performance.The JD requires joint channel estimation (JCE) for the two signals. However, the JCE makes the implementation of the JD more difficult, since it requires synchronised network and unique training sequences with low cross-correlation for the two signals.
机译:本文介绍了改善TDMA移动无线电系统性能的接收机算法。特别地,我们考虑了利用辅助信息的接收机,该辅助信息可以从差错控制编码中获得或通过具有干扰源的先验知识来获得。前者可以采用迭代方法,后者则可以采用干扰抑制技术。卷积编码将冗余信息添加到信号中,从而保护通过无线电信道传输的消息。在编码系统中,由于复杂性的限制,接收机通常包括单独的信道估计,检测和信道解码任务。与通过优化信息比特,传输符号和信道冲激响应的联合概率而获得的最佳解决方案相比,该次优解决方案的性能下降。常规接收机在信道解码中利用检测到的符号中的估计信道状态信息和信道解码中的检测符号来最终获得信息比特。但是,信道解码器还提供有关位概率的外部信息,该信息与均衡器输入处接收的信息无关。因此,使用此新的外部信息以及原始输入信号重新执行信道估计和检测是有益的。我们将迭代接收器技术主要应用于使用GMSK调制进行迭代信道估计和8-PSK的增强型通用分组无线系统(EGPRS)调制用于迭代检测方案。迭代检测的典型增益约为2 dB,而迭代信道估计的典型增益约为1 dB。此外,我们建议进行两次迭代,以实现合理的复杂性/性能折衷。为了进一步降低复杂度,我们引入了软网格解码技术,该技术可以在迭代方案中显着降低解码器的复杂度。同信道干扰(CCI)来自附近的小区,这些小区重用了相同的传输频率。在本文中,我们考虑通过联合检测(JD)技术抑制CCI,该技术可同时检测所需信号和干扰信号。由于复杂性的限制,我们仅考虑两个二进制调制信号的JD。因此,重要的是找到主要的干扰信号(DI)以达到最佳性能。在一个强大的DI的情况下,JD大大改善了接收机性能.JD需要对两个信号进行联合信道估计(JCE)。但是,JCE使得JD的实施更加困难,因为它需要同步的网络和唯一的训练序列,且两个信号的互相关性都较低。

著录项

  • 作者

    Pukkila Markku;

  • 作者单位
  • 年度 2003
  • 总页数
  • 原文格式 PDF
  • 正文语种 en
  • 中图分类

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号