首页> 外文OA文献 >Beam-loss induced pressure rise of Large Hadron Collider collimator materials irradiated with 158 GeV/u $In^{49+}$ ions at the CERN Super Proton Synchrotron
【2h】

Beam-loss induced pressure rise of Large Hadron Collider collimator materials irradiated with 158 GeV/u $In^{49+}$ ions at the CERN Super Proton Synchrotron

机译:在CERN超级质子同步加速器上用158 GeV / u $ In ^ {49 +} $离子辐照的大型强子对撞机准直器材料的束流损失引起的压力上升

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

During heavy ion operation, large pressure rises, up to a few orders of magnitude, were observed at CERN, GSI, and BNL. The dynamic pressure rises were triggered by lost beam ions that impacted onto the vacuum chamber walls and desorbed about 10/sup 4/ to 10/sup 7/ molecules per ion. The deterioration of the dynamic vacuum conditions can enhance charge-exchange beam losses and can lead to beam instabilities or even to beam abortion triggered by vacuum interlocks. Consequently, a dedicated measurement of heavy-ion induced molecular desorption in the GeV/u energy range is important for Large Hadron Collider (LHC) ion operation. In 2003, a desorption experiment was installed at the super proton synchrotron to measure the beam-loss induced pressure rise of potential LHC collimator materials. Samples of bare graphite, sputter coated (Cu, TiZrV) graphite, and 316 LN (low carbon with nitrogen) stainless steel were irradiated under grazing angle with 158 GeV/u indium ions. After a description of the new experimental setup, the results of the pressure rise measurements are presented, and the derived desorption yields are compared with data from other experiments.
机译:在重离子运行期间,在CERN,GSI和BNL处观察到大的压力上升,达到几个数量级。动态压力上升是由丢失的离子束触发的,这些离子束撞击到真空室壁上,每个离子解吸的分子约为10 / sup 4 /至10 / sup 7 /分子。动态真空条件的恶化会增加电荷交换束的损失,并可能导致束不稳定,甚至导致由于真空互锁而引起的束流中止。因此,对于大型强子对撞机(LHC)离子操作,专门测量在GeV / u能量范围内重离子诱导的分子解吸非常重要。 2003年,在超级质子同步加速器上安装了解吸实验,以测量潜在的LHC准直仪材料的束流损失引起的压力升高。以158 GeV / u的铟离子在掠射角下辐照裸露的石墨,溅射镀膜的(Cu,TiZrV)石墨和316 LN(含氮低碳)不锈钢的样品。在对新的实验装置进行描述之后,将介绍压力上升测量的结果,并将得出的解吸率与其他实验的数据进行比较。

著录项

相似文献

  • 外文文献
  • 中文文献
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号