首页> 外文OA文献 >Multi-Representation of Symbolic and Nonsymbolic Numerical Magnitude in Chinese Number Processing
【2h】

Multi-Representation of Symbolic and Nonsymbolic Numerical Magnitude in Chinese Number Processing

机译:中文数字处理中符号和非符号数值幅度的多重表示

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Numerical information can be conveyed by either symbolic or nonsymbolic representation. Some symbolic numerals can also be identified as nonsymbolic quantities defined by the number of lines (e.g., I, II, III in Roman and , , in Japanese Kanji and Chinese). Here we report that such multi-representation of magnitude can facilitate the processing of these numerals under certain circumstances. In a magnitude comparison task judging 1 to 9 (except 5) Chinese and Arabic numerals presented at the foveal (at the center) or parafoveal (3° left or right of the center) location, multi-representational small-value Chinese numerals showed a processing advantage over single-representational Arabic numerals and large-value Chinese numerals only in the parafoveal condition, demonstrated by lower error rates and faster reaction times. Further event-related potential (ERP) analysis showed that such a processing advantage was not reflected by traditional ERP components identified in previous studies of number processing, such as N1 or P2p. Instead, the difference was found much later in a N400 component between 300–550 msec over parietal regions, suggesting that those behavioral differences may not be due to early processing of visual identification, but later processing of subitizing or accessing mental number line when lacking attentional resources. These results suggest that there could be three stages of number processing represented separately by the N1, P2p and N400 ERP components. In addition, numerical information can be represented simultaneously by both symbolic and nonsymbolic systems, which will facilitate number processing in certain situations.
机译:数字信息可以通过符号或非符号表示来传达。某些符号数字也可以标识为由行数定义的非符号数量(例如,罗马和I,II,III,日语汉字和中文)。在此我们报告,这种幅度的多重表示可以在某些情况下促进这些数字的处理。在一个幅度比较任务中,判断在中央凹(中心)或副中央凹(中心左或右3°)位置出现的1到9(5个除外)中文和阿拉伯数字,多表示小数值汉字显示仅在副凹位置条件下,它比单一代表阿拉伯数字和大数值中文数字具有更大的处理优势,这体现在较低的错误率和更快的反应时间上。进一步的事件相关电位(ERP)分析表明,这种处理优势没有被以前的数字处理研究(例如N1或P2p)中确定的传统ERP组件所反映。取而代之的是,该差异是在N400组件的顶峰区域300–550毫秒之间发现的,这一点要晚得多,这表明这些行为差异可能不是由于视觉识别的早期处理,而是由于缺乏注意而后来对主题编号线进行替换或访问的处理。资源。这些结果表明,可以由N1,P2p和N400 ERP组件分别代表数字处理的三个阶段。此外,数字信息可以同时由符号系统和非符号系统表示,这将有助于在某些情况下进行数字处理。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号