首页> 外文OA文献 >Construção e analise de desempenho de um sistema de aquecimento solar de água utilizando placa de policarbonato como superfície absorvedora
【2h】

Construção e analise de desempenho de um sistema de aquecimento solar de água utilizando placa de policarbonato como superfície absorvedora

机译:以聚碳酸酯板为吸收面的太阳能热水系统的构造与性能分析

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

It was studied a system for heating water to be used to obtain water for bathing athome, the absorbing surface of the collector is formed by one plate of polycarbonate. Thepolycarbonate plate has 6 mm thick, 1.050 mm wide and 1.500 mm long with an area equal to1,575 m². The plate was attached by its edges parallel to PVC tubes of 32 mm. The systemworked under the thermo-siphon and was tested for two configurations: plate absorber withand without isolation of EPS of 30 mm thick on the bottom surface in order to minimize heatlosses from the bottom. The tank's thermal heating system is alternative and low cost, since itwas constructed from a polyethylene reservoir for water storage, with a volume of 200 liters.Will present data on the thermal efficiency, heat loss, water temperature of thermal reservoirat the end of the process simulation and baths. Will be demonstrated the feasibility of thermal,economic and material pickup proposed for the intended purpose.
机译:研究了一种用于加热水的系统,该系统用于获得在家洗澡的水,收集器的吸收表面由一块聚碳酸酯制成。聚碳酸酯板厚6毫米,宽1.050毫米,长1.500毫米,面积等于1,575平方米。板的边缘平行于32 mm的PVC管固定。该系统在热虹吸管下工作,并进行了两种配置的测试:板式吸收器,在底表面有和没有隔离30毫米厚EPS的板式吸收器,以最大程度降低底部的热损失。该水箱的热加热系统是可替代的且成本低廉,因为它是由一个容积为200升的聚乙烯储水器构成的,将在处理结束时提供有关热效率,热损失,水储器水温的数据模拟和沐浴。将证明为预期目的提议的热,经济和材料拾取的可行性。

著录项

  • 作者

    Sodré Dilton;

  • 作者单位
  • 年度 2010
  • 总页数
  • 原文格式 PDF
  • 正文语种 por
  • 中图分类

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号