首页> 外文OA文献 >Aerothermodynamic Analysis of Commercial Experiment Transporter (COMET) Reentry Capsule
【2h】

Aerothermodynamic Analysis of Commercial Experiment Transporter (COMET) Reentry Capsule

机译:商业实验运输器(COMET)再入胶囊的空气热力学分析

摘要

An aerothermodynamic analysis of the Commercial Experiment Transporter (COMET) reentry capsule has been performed using the laminar thin-layer Navier-Stokes solver Langley Aerothermodynamic Upwind Relaxation Algorithm. Flowfield solutions were obtained at Mach numbers 1.5, 2, 5, 10, 15, 20, 25, and 27.5. Axisymmetric and 5, 10, and 20 degree angles of attack were considered across the Mach-number range, with the Mach 25 conditions taken to 90 degrees angle of attack and the Mach 27.5 cases taken to 60 degrees angle of attack. Detailed surface heat-transfer rates were computed at Mach 20 and 25, revealing that heating rates on the heat-shield shoulder ,can exceed the stagnation-point heating by 230 percent. Finite-rate chemistry solutions were performed above Mach 10, otherwise perfect gas computations were made. Drag, lift, and pitching moment coefficients are computed and details of a wake flow are presented. The effect of including the wake in the solution domain was investigated and base pressure corrections to forebody drag coefficients were numerically determined for the lower Mach numbers. Pitching moment comparisons are made with direct simulation Monte Carlo results in the more rarefied flow at the highest Mach numbers, showing agreement within two-percent. Thin-layer Navier-Stokes computations of the axial force are found to be 15 percent higher across the speed range than the empirical/Newtonian based results used during the initial trajectory analyses.
机译:使用层状薄层Navier-Stokes求解器Langley空气热动力逆风弛豫算法对商业实验运输器(COMET)再入舱进行了空气热力学分析。以1.5、2、5、10、15、20、25和27.5的马赫数获得流场解决方案。在整个马赫数范围内考虑了轴对称,5度,10度和20度的迎角,其中25马赫条件下的迎角为90度,马赫27.5情况下的迎角为60度。详细的表面传热速率是在20马赫和25马赫时计算得出的,表明隔热罩肩部的加热速率可以比停滞点加热高出230%。在10马赫以上的温度下执行有限速率的化学溶液,否则将进行完美的气体计算。计算阻力,升力和俯仰力矩系数,并给出尾流的细节。研究了在解决方案域中包括尾流的影响,并针对较低的马赫数通过数值确定了前体阻力系数的基础压力修正值。通过直接模拟进行俯仰力矩比较,蒙特卡洛结果在最高马赫数下流动更为稀疏,显示出在2%以内的一致性。发现在整个速度范围内,轴向力的薄层Navier-Stokes计算要比初始轨迹分析中使用的基于经验/牛顿法的结果高15%。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号