Three-dimensional electrical conductivity structure beneath Australia from inversion of geomagnetic observatory data: evidence for lateral variations in transition-zone temperature, water content and melt

摘要

In this paper, we report the 3-D electrical conductivity distribution beneath the Australian continent in the depth range 410-1600 km, which we have imaged by inverting C-response estimates from a regional network of geomagnetic observatories. The inversion scheme is based on a quasi-Newton optimization method while the forward algorithm relies on an integral-equation approach. To properly account for the ocean effect in responses at coastal observatories we included a high-resolution (1°×1°) fixed thin laterally varying surface conductance layer. As starting model in the inversion we considered a laboratory-based 3-D conductivity model of the region obtained from seismic surface wave data and thermodynamic modelling. This model provides a good fit to observed C-response estimates supporting its choice as initial model. The most striking feature of the obtained 3-D model is a high-conductivity anomaly in the lower part of the mantle transition zone (MTZ; 520-660 km depth) beneath southeastern Australia implying considerable lateral as radial heterogeneity in the conductivity structure. The high-conductivity region appears to be 0.5-1 log units more conductive than previous global and other regionalized 1-D models. Further analysis using laboratory-based conductivity models combined with thermochemical phase equilibrium computations shows that the strong conductivity anomaly implies water contents of around 0.1 wt per cent in the upper part and >0.4 wt per cent in the lower part of the MTZ. This implies a large MTZ water reservoir that likely totals one to three times that which currently resides in the oceans. The amount of water in the lower MTZ appears to exceed the experimentally determined water storage capacity of the main lower MTZ mineral ringwoodite, which, as a result, undergoes dehydration-induced partial melting. Including contributions to conductivity from a thin melt layer (20 km thick) located in the mid-MTZ increases conductivity locally in the melt layer to ∼1 S m−1, that is, about 0.5 log units more conductive than the average surrounding mantle. This provides an adequate explanation for the strong conductivity anomalies observed beneath part of the continent and points to lateral variations in melt in the MTZ