Conception d’alimentations de puissance d’actionneurs piézo-électriques, avec et sans contact électrique, pour la génération des vibrations mécaniques

摘要

Placed on the rotating part of a drilling system. These actuators have a capacitive behavior and are usually supplied by linear systems. In this case, the design and the sizing of different switching amplifiers that provide, in a fixed frame, a sinusoidal power signal with modular frequency in the best possible conditions (efficiency and THD) have been made. Then, a contactless power system for piezoelectric actuators placed in a rotating frame was analyzed. This was possible thanks to the use of induction systems through a rotating transformer with an air gap. Three types of contactless systems were studied. The first one works at modular low frequencies [50-500 Hz] and the other two use resonant strategies in order to reduce transformer’s size. For this, both magnetic and electrical modeling was performed in the three cases.A full-bridge inverter prototype that can deliver up to 680 VAR and a low frequency contactless energy transfer system of 1.75 kVAR that supplies the piezoelectric actuator at rotating frame have been made. Experimental results showed satisfactory results and proved the system feasibility.