首页> 外文OA文献 >A Simulation Based Study and Analysis of Double Gate Tunnel FET Performance for Low Stand-By Power Applications
【2h】

A Simulation Based Study and Analysis of Double Gate Tunnel FET Performance for Low Stand-By Power Applications

机译:低待机功率应用中基于仿真的双栅极隧道FET性能研究与分析

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

The conventional metal oxide semiconductor field effect transistor (MOSFET)may not be suitable for future low standby power (LSTP) applications due to its high off-state current as the sub-threshold swing is theoretically limited to 60mV/decade. Tunnel field effect transistor (TFET) based on gate controlled band to band tunneling has attracted attention for such applications due to its extremely small sub-threshold swing (much less than 60mV/decade). This paperudtakes a simulation approach to gain some insight into its electrostatics and the carrier transport mechanism. Using 2D device simulations, a thorough study and analysis of the electrical parameters of the planar double gate TFET isudperformed. Due to excellent sub-threshold characteristics and a reverse biased structure, it offers orders of magnitude less leakage current compared to the conventional MOSFET. In this work, it is shown that the device can be scaled down to channel lengths as small as 30 nm without affecting its performance. Also, it is observed that the bulk region of the device plays a major role in determining the sub-threshold characteristics of the device and considerable improvement in performance (in terms of ION/IOFF ratio) can be achieved if the thickness of the device is reduced. An ION/IOFF ratio of 2x1012 and a minimumudpoint sub-threshold swing of 22mV/decade is obtained.
机译:传统的金属氧化物半导体场效应晶体管(MOSFET)由于其高断态电流而可能不适合将来的低待机功率(LSTP)应用,因为亚阈值摆幅理论上限制在60mV /十倍。基于栅极控制的带间隧穿的隧道场效应晶体管(TFET)由于其极小的亚阈值摆幅(远小于60mV /十倍频程)而引起了人们的关注。本文采用模拟方法来深入了解其静电和载流子传输机制。使用2D器件仿真,可以对平面双栅极TFET的电参数进行彻底的研究和分析。由于出色的亚阈值特性和反向偏置结构,与传统的MOSFET相比,它的漏电流要小几个数量级。在这项工作中,表明该设备可以缩小到30 nm的通道长度,而不会影响其性能。此外,可以观察到,器件的主体区域在确定器件的亚阈值特性中起着重要作用,如果器件的厚度为10毫米,则可以实现性能的显着提高(就ION / IOFF比而言)。减少。获得的ION / IOFF比率为2x1012,最小欠点子阈值摆幅为22mV /十倍。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号