首页> 外文OA文献 >The effect of discharge chamber geometry on the ignition of low-pressure rf capacitive discharges
【2h】

The effect of discharge chamber geometry on the ignition of low-pressure rf capacitive discharges

机译:放电室几何形状对低压射频电容放电的点火的影响

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

This paper reports measured and calculated breakdown curves in several gases of rf capacitive discharges excited at 13.56 MHz in chambers of three different geometries: parallel plates surrounded by a dielectric cylinder (“symmetric parallel plate”), parallel plates surrounded by audgrounded metallic cylinder (“asymmetric parallel plate”), and parallel plates inside a much larger grounded metallic chamber (“large chamber”). The breakdown curves for the symmetric chamber have a multivalued section at low pressure. For the asymmetric chamber the breakdown curves are shifted to lower pressures and rf voltages, but the multivalued feature is still present. At higher pressures the breakdown voltages are much lower than for the symmetric geometry. For the large chamber geometry the multivalued behavior is not observed. The breakdown curves were also calculated using a numerical model based on fluid equations, giving results that are in satisfactoryudagreement with the measurements.
机译:本文报告了在三种不同几何形状的腔室中以13.56 MHz激发的几种射频电容放电气体的测量和计算出的击穿曲线:三个被绝缘圆柱体包围的平行板(“对称平行板”),被金属接地的平行板(“不对称平行板”)和更大接地的金属腔(“大腔”)内的平行板。对称腔的击穿曲线在低压下具有多值截面。对于非对称腔室,击穿曲线转移到较低的压力和rf电压,但仍然存在多值特征。在较高的压力下,击穿电压远低于对称几何形状。对于大腔室几何形状,未观察到多值行为。还使用基于流体方程的数值模型来计算击穿曲线,得出的结果与测量结果令人满意/令人满意。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号