首页> 外文OA文献 >Analysis of Mass Flow and Enhanced Mass Flow Methods of Flashing Refrigerant-22 from a Small Vessel
【2h】

Analysis of Mass Flow and Enhanced Mass Flow Methods of Flashing Refrigerant-22 from a Small Vessel

机译:小容器中闪蒸制冷剂-22的质量流分析和增强质量流方法

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

The mass flow characteristics of flashing Refrigerant-22 from a small vessel were investigated. A flash boiling apparatus was designed and built. It was modeled after the flashing process encountered by the accumulator of air-source heat pump systems. Three small pyrex glass vessels were used to hold the refrigerant and allow for visualization studies of the flashing process. Baseline experiments were run varying initial pressure, initial refrigerant amount, orifice diameter, and vessel geometry. Three sets of experiments were run using two passive enhancement methods (the addition of steel balls and the addition of small amounts of oil) and one active enhancement method (the addition of an immersion heater). Furthermore, a lumped-parameter analytical model was developed from basic thermodynamic principles that predicted the rate of depressurization for the flashing refrigerant. The study showed that the initial refrigerant amount and the orifice size had the greatest influence on the mass flow and pressure characteristics during each sixty second test. The initial pressure and vessel volume had less of an impact under the conditions tested. Two of the enhancement methods consistently increased the amount of refrigerant flashed during the tests as compared to the baseline data for the same initial conditions. The addition a 1 cm layer of 3.6 mm steel balls to the base of the vessel increased the amount flashed from 21% to 81% and the addition of the 215-watt flat-spiral immersion heater the increased the amount flashed from 47% to 111 %. Foaming at the vapor-liquid interface was observed with the refrigerant-oil mixture experiments as two of the eight test conditions averaged an increase while six averaged a decrease, ranging from a 21% increase to a 27% decrease. The analytical depressurization model predicted general pressure and mass flux trends, and revisions to the model improved pressure predictions to within ?11%.
机译:研究了从小型容器中闪蒸出的Refrigerant-22的质量流量特性。设计并制造了闪蒸装置。它是根据空气源热泵系统的蓄热器遇到的闪蒸过程进行建模的。使用三个小的耐热玻璃玻璃容器来容纳制冷剂,并允许对闪蒸过程进行可视化研究。基线实验是通过改变初始压力,初始制冷剂量,孔口直径和容器几何形状来进行的。使用两种被动增强方法(添加钢球和少量油)和一种主动增强方法(添加浸入式加热器)进行了三组实验。此外,根据基本热力学原理建立了集总参数分析模型,该模型预测了闪蒸制冷剂的降压速度。研究表明,在每60秒测试期间,初始制冷剂量和节流孔尺寸对质量流量和压力特性的影响最大。在测试条件下,初始压力和容器体积的影响较小。与相同初始条件下的基线数据相比,两种增强方法在测试过程中持续增加了闪蒸的制冷剂数量。向容器底部添加1厘米的3.6毫米钢球层,将闪蒸的数量从21%增加到81%;添加215瓦的扁平螺旋浸没式加热器,将闪蒸的数量从47%增加到111 %。在制冷剂-油混合物实验中观察到在气-液界面处起泡,因为八个测试条件中的两个平均增加,而六个平均减少,从增加21%到减少27%。解析降压模型预测了总体压力和质量通量趋势,对该模型的修订将压力预测提高到了11%以内。

著录项

  • 作者

    Nutter Darin Wayne;

  • 作者单位
  • 年度 1994
  • 总页数
  • 原文格式 PDF
  • 正文语种 en_US
  • 中图分类

相似文献

  • 外文文献
  • 中文文献
  • 专利

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号