Evaluation of a Balloon-Type Vaginal Endoscope Based on Three-Dimensional Printing Technology for Self-Assessment of Pelvic Organ Prolapse

摘要

Pelvic organ prolapse (POP) can occur if the support tissues or the pelvic floor muscles are weakened and damaged. There is increased probability for POP occurrence after childbirth, menopause, or in overweight women. Because the natural history and progression of POP is still unknown, the approaches used to prevent it have not been clear. POP is an uncomfortable condition that affects one every three women. However, most people feel uncomfortable to discuss it. Herein, we conducted a feasibility evaluation study for self-assessment approaches with a vaginal endoscope based on three-dimensional (3D) printing. The proposed endoscope has two parts: (a) rubber material used to cover it for its intended insertion, to avoid direct contact with the walls of the vagina, and (b) two types of sensors at the tip for measurements. The condition inside the vagina was observed with a camera and depth sensors based on the regulation of the amount of air. Arbitrary temporary prolapses from the testbed’s generator enabled us to perceive the location of the problem and symptoms that were regarded as the early stage. As discussed, the low-cost design of the 3D-printed-based vaginal endoscope provides a self-check capability and allows continuous observations that help prevent POP.