首页> 外文OA文献 >Virtual Structural Analysis of Jokisivu Open Pit Using ‘Structure-from-Motion’ Unmanned Aerial Vehicles (UAV) Photogrammetry: Implications for Structurally-Controlled Gold Deposits in Southwest Finland
【2h】

Virtual Structural Analysis of Jokisivu Open Pit Using ‘Structure-from-Motion’ Unmanned Aerial Vehicles (UAV) Photogrammetry: Implications for Structurally-Controlled Gold Deposits in Southwest Finland

机译:使用“结构 - 从动作”无人机(UAV)摄影测量的Jokisivu Open Pit的虚拟结构分析:在西南部的结构控制金矿床中的影响

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

Unmanned aerial vehicles (UAVs) are rapidly growing remote sensing platforms for capturing high-resolution images of exposed rock surfaces. We used a DJI Phantom 3 Professional (P3P) quadcopter to capture aerial images that were used to generate a high-resolution three-dimensional (3-D) model of the Jokisivu open-pit gold deposit that is located in southwestern Finland. 158 overlapping oblique and nadir images were taken and processed with Agisoft Photoscan Pro to generate textured 3-D surface models. In addition, 69 overlapping images were taken from the steep faces of the open pit. We assessed the precision of the 3-D model by deploying ground control points (GCPs) and the average errors were found minimal along X (2.0 cm), Y (1.2 cm), and Z (5.0 cm) axes. The steep faces of the open pit were used for virtual structural measurements and kinematic analyses in CloudCompare and ArcGIS to distinguish the orientation of different fracture sets and statistical categorization, respectively. Three distinct fracture sets were observed. The NW-SE and NE-SW striking fractures form a conjugate geometry, whereas the NNW-SSE striking fractures cut the conjugate fracture set. The orientation of conjugate fractures match well with the resource model of the deposit and NW- and NE-trending segments of regional-scale anastomosing shear zones. Based on the conjugate geometry of fracture sets I and II, and the regional pattern of anastomosing shear system lead us to interpret an origin of gold mineralization in two stages. An early N-S or NNW-SSE crustal shortening, corresponding to the regional D4 (ca. 1.83–1.81 Ga) or pre-D4 (ca. 1.87–1.86 Ga) Svecofennian tectonic event(s) that produced anastomosing shear zones. Subsequent E-W directed D5 contraction (ca. 1.79–1.77 Ga) partly reactivated the anastomosing shear zones with the formation of conjugate system, which controlled the migration of fluids and gold mineralization in SW Finland.
机译:无人驾驶飞行器(无人机)是迅速增长的遥感平台,用于捕获暴露的岩石表面的高分辨率图像。我们使用DJI Phantom 3 Professional(P3P)Quadcopter捕获用于产生位于芬兰西南部的Jokisivu Open-Pit金矿床的高分辨率三维(3-D)模型。使用Agisoft Photoscan Pro进行了158次重叠斜和Nadir图像,以产生纹理的3-D表面模型。另外,从露天坑的陡峭面上取出69个重叠图像。我们通过部署地面控制点(GCP)来评估3-D模型的精度,并且发现平均误差沿X(2.0cm),y(1.2cm)和z(5.0cm)轴最小。露天坑的陡脸用于云组织和ArcGIS中的虚拟结构测量和运动学分析,分别区分不同骨折组和统计分类的方向。观察到三个不同的骨折组。 NW-SE和NE-SW引起的骨折形成缀合物几何形状,而NNW-SSE引起的骨折切割缀合物骨折组。缀合物骨折的取向与区域规模吻合剪切区的沉积物和NW和NE趋势片段的资源模型相匹配。基于骨折的缀合物几何形状I和II,吻合剪切系统的区域模式引导我们在两个阶段解释金矿化的起源。早期的N-S或NNW-SSE地壳缩短,对应于区域D4(CA.1.83-1.81 GA)或PRE-D4(CA.1.87-1.86 GA)SVecofennian的构造事件,产生吻合剪切区。随后的E-W定向D5收缩(1.79-1.77 Ga)部分重新激活了缀合物系统的形成,该系统控制了SW芬兰流体和金矿化的迁移。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号