首页> 外文OA文献 >Zn vacancy complex-determined filamentary resistive switching characteristics in Au/ZnSe/ITO chalcogenide-based memory cells
【2h】

Zn vacancy complex-determined filamentary resistive switching characteristics in Au/ZnSe/ITO chalcogenide-based memory cells

机译:Au / ZnSe / ITO基于Chalcogenide的存储器单元中的Zn空位复合丝状电阻切换特性

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

ZnSe films with a sphalerite structure and about 100nm grain size were deposited on ITO substrate. 200 stable bipolar resistive switching (RS) cycles were obtained in Au/ZnSe/ITO chalcogenide-based memory cells and it shows an ON/OFF ratio of 10 and retention time of 104 seconds. The conduction mechanism is Ohmic in both low resistance state (LRS) and low voltage region in high resistance state (HRS) while thermionic emission limited conduction (TELC) at high voltage region in HRS. The top electrode (TE) size independence of low resistance implies a filamentary resistive switching mechanism. Photoluminescence (PL) spectroscopy shows a double difference of relative intensity between shallow zinc vacancy state and deep zinc vacancy complex state in HRS and LRS. The explanation for HRS is the dissociation of zinc vacancy complex and the formation of zinc vacancy. Then the shallow acceptor zinc vacancy compensates for the shallow donor contributing the HRS. It is deduced from linear relation of reset voltage and reset power versus temperature that the thermal activation energy of ZnSe film is 0.19 eV, which indicates an over 20nm intertrap distance and the critical temperature for conductive filament (CF) rupture is 305.6K with 0.2mV/s sweep rate, respectively. The component of CF is metal-like shallow donor such as Al or Ga with the help of deep zinc vacancy complex to depress the compensation of shallow zinc vacancy acceptor.
机译:锌具有闪锌矿结构和约100nm粒度的锌膜沉积在ITO底物上。在基于Au / ZnSe / ITO硫属化物的存储器单元中获得200稳定的双极电阻切换(RS)循环,其显示为10的开/关比和104秒的保留时间。导通机构在低电阻状态(LRS)和高电阻状态(HRS)的低电压区域中欧姆,而HRS中的高压区域的热离子发射有限导通(TELC)。低电阻的顶部电极(TE)尺寸独立性意味着丝状电阻切换机构。光致发光(PL)光谱显示HRS和LRS中浅锌空位状态和深锌空位复合状态之间的相对强度的双重差异。 HRS的解释是锌空位复合物的解离和锌空位的形成。然后浅层受体锌空位补偿了促进HRS的浅供体。它是从复位电压和复位电源与温度即ZnSe膜的热激活能为0.19电子伏特,这表明过20nm的intertrap距离和导电丝(CF)破裂的临界温度的线性关系推导是305.6K与0.2mV / s分别扫描率。 CF的组分是金属状浅供体,如Al或Ga,借助于深锌空位复合物,以抑制浅锌空位受体的补偿。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
代理获取

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号