The disposal of industrial waste sludge at a landfill has become a global problem especially when dealing with high moisture content material. Neutralisation Spent Pickle Liquor (NSPL) sludge waste generated in steel industry has been categorized as one of the slurry wastes in geotechnical engineering and poses serious handling problem due to its high water content. The NSPL sludge waste is categorized as a high water content material with a low solid concentration.The main objective in this paper is present a study related to compressive behaviour of the NSPL sludge material under external load. A series of consolidation tests of different NSPL initial water content and load pressure using Rowe cell equipment were performed. The consolidation behaviour of the NSPL sludge was shown to be complex, especially during the initial stages of the loading process. For any given load increment, an instantaneous compression was observed but no pore water dissipation were detected. The coefficient of permeability was found to be very high during the first few minutes, i.e. in the range of 10-4 – 10-5 m/s, and reduces significantly to 10-10 m/s after the first 17 hours of the test. The compression behaviour of the sludge materials are directly related to their coefficient of permeability
展开▼
机译:在垃圾填埋场处置工业废物污泥已成为全球性问题,尤其是在处理高水分含量的材料时。钢铁行业产生的中和废酸洗液(NSPL)污泥废物被归类为岩土工程中的一种淤浆废物,并且由于其含水量高而造成严重的处理问题。 NSPL污泥废物被归类为高含水量固体含量低的物质。本文的主要目的是研究与NSPL污泥物质在外部载荷下的压缩行为有关。使用Rowe池设备进行了一系列不同的NSPL初始含水量和负载压力的固结测试。事实证明,NSPL污泥的固结行为很复杂,尤其是在装载过程的初始阶段。对于任何给定的载荷增量,均会观察到瞬时压缩,但未检测到孔隙水耗散。发现在最初的几分钟内渗透系数非常高,即在10-4 – 10-5 m / s的范围内,并且在测试的前17小时后显着降低到10-10 m / s 。污泥材料的压缩行为与其渗透系数直接相关。
展开▼