首页> 外文OA文献 >The Performance of House Foundations in the Canterbury Earthquakes
【2h】

The Performance of House Foundations in the Canterbury Earthquakes

机译:坎特伯雷地震中房屋基金会的表现

代理获取
本网站仅为用户提供外文OA文献查询和代理获取服务,本网站没有原文。下单后我们将采用程序或人工为您竭诚获取高质量的原文,但由于OA文献来源多样且变更频繁,仍可能出现获取不到、文献不完整或与标题不符等情况,如果获取不到我们将提供退款服务。请知悉。

摘要

The Canterbury Earthquakes of 2010-2011, in particular the 4th September 2010 Darfield earthquake and the 22nd February 2011 Christchurch earthquake, produced severe and widespread liquefaction in Christchurch and surrounding areas. The scale of the liquefaction was unprecedented, and caused extensive damage to a variety of man-made structures, including residential houses. Around 20,000 residential houses suffered serious damage as a direct result of the effects of liquefaction, and this resulted in approximately 7000 houses in the worst-hit areas being abandoned.Despite the good performance of light timber-framed houses under the inertial loads of the earthquake, these structures could not withstand the large loads and deformations associated with liquefaction, resulting in significant damage. The key structural component of houses subjected to liquefaction effects was found to be their foundations, as these are in direct contact with the ground. The performance of house foundations directly influenced the performance of the structure as a whole. Because of this, and due to the lack of research in this area, it was decided to investigate the performance of houses and in particular their foundations when subjected to the effects of liquefaction.The data from the inspections of approximately 500 houses conducted by a University of Canterbury summer research team following the 4th September 2010 earthquake in the worst-hit areas of Christchurch were analysed to determine the general performance of residential houses when subjected to high liquefaction loads. This was followed by the detailed inspection of around 170 houses with four different foundation types common to Christchurch and New Zealand: Concrete perimeter with short piers constructed to NZS3604, concrete slab-on-grade also to NZS3604, RibRaft slabs designed by Firth Industries and driven pile foundations. With a focus on foundations, floor levels and slopes were measured, and the damage to all areas of the house and property were recorded. Seven invasive inspections were also conducted on houses being demolished, to examine in more detail the deformation modes and the causes of damage in severely affected houses. The simplified modelling of concrete perimeter sections subjected to a variety of liquefaction-related scenarios was also performed, to examine the comparative performance of foundations built in different periods, and the loads generated under various bearing loss and lateral spreading cases.It was found that the level of foundation damage is directly related to the level of liquefaction experienced, and that foundation damage and liquefaction severity in turn influence the performance of the superstructure. Concrete perimeter foundations were found to have performed most poorly, suffering high local floor slopes and being likely to require foundation repairs even when liquefaction was low enough that no surface ejecta was seen. This was due to their weak, flexible foundation structure, which cannot withstand liquefaction loads without deforming. The vulnerability of concrete perimeter foundations was confirmed through modelling. Slab-on-grade foundations performed better, and were unlikely to require repairs at low levels of liquefaction. Ribraft and piled foundations performed the best, with repairs unlikely up to moderate levels of liquefaction. However, all foundation types were susceptible to significant damage at higher levels of liquefaction, with maximum differential settlements of 474mm, 202mm, 182mm and 250mm found for concrete perimeter, slab-on-grade, ribraft and piled foundations respectively when subjected to significant lateral spreading, the most severe loading scenario caused by liquefaction.It was found through the analysis of the data that the type of exterior wall cladding, either heavy or light, and the number of storeys, did not affect the performance of foundations. This was also shown through modelling for concrete perimeter foundations, and is due to the increased foundation strengths provided for heavily cladded and two-storey houses. Heavy roof claddings were found to increase the demands on foundations, worsening their performance. Pre-1930 concrete perimeter foundations were also found to be very vulnerable to damage under liquefaction loads, due to their weak and brittle construction.
机译:2010-2011年的坎特伯雷地震,特别是2010年9月4日的达菲尔德地震和2011年2月22日的克赖斯特彻奇地震,在克赖斯特彻奇及周边地区产生了严重而广泛的液化。液化的规模是空前的,对包括住宅在内的各种人造结构造成了广泛的破坏。由于液化的影响,约有20,000座房屋遭受了严重破坏,这使受灾最严重的地区约有7,000座房屋被废弃。尽管在地震的惯性载荷下,轻木结构房屋的性能良好,这些结构无法承受与液化有关的大载荷和变形,从而导致严重损坏。人们发现,受到液化作用的房屋的主要结构成分是其基础,因为它们直接与地面接触。房屋基础的性能直接影响整个结构的性能。因此,由于缺乏该领域的研究,因此决定研究房屋在受到液化影响时的性能,尤其是其基础。一所大学对大约500所房屋进行检查的数据分析了克赖斯特彻奇受灾最严重地区2010年9月4日地震后坎特伯雷夏季研究小组的成员,以确定承受高液化负荷的住宅的总体性能。随后详细检查了约170座房屋,这些房屋有基督城和新西兰共有的四种不同地基类型:按照NZS3604建造的带有短墩的混凝土周长,也按照NZS3604建造的混凝土楼板,由Firth Industries设计并驱动的RibRaft楼板桩基础。以地基为重点,测量了地面和坡度,并记录了房屋和财产所有区域的损坏情况。还对要拆除的房屋进行了七次侵入性检查,以更详细地检查严重受影响房屋的变形模式和损坏原因。还进行了简化的混凝土周边部分的建模,这些周边部分经历了各种与液化有关的情况,以检查在不同时期建造的地基的比较性能,以及在各种轴承损耗和横向扩展情况下产生的载荷。地基的破坏程度直接与所经历的液化程度有关,而地基的破坏程度和液化的强度反过来会影响上部结构的性能。发现混凝土周边地基的性能最差,局部地面坡度较高,即使液化程度很低以至于看不到表面喷出物,也可能需要对地基进行维修。这是因为它们的基础结构薄弱,柔软,无法承受液化载荷而不会变形。通过模型确定了混凝土周边基础的脆弱性。平板混凝土地基性能更好,在低液化水平下不太可能需要维修。 Ribraft和打桩的地基性能最好,修复到中等程度的液化不太可能。但是,所有类型的基础在较高的液化水平下都容易受到明显的破坏,当混凝土周向,地基平板,肋筏和桩基在横向扩展时,最大差异沉降分别为474mm,202mm,182mm和250mm。液化引起的最严重的荷载情况。通过对数据的分析发现,外墙覆层的类型(重或轻)以及层数均不影响地基的性能。这也通过对混凝土周边基础进行建模得到了证明,这是由于为重覆的两层房屋提供了增强的基础强度。人们发现重型屋顶覆盖层增加了对地基的需求,从而降低了其性能。还发现1930年前的混凝土周边地基由于其脆弱而脆弱的结构,在液化载荷下非常容易损坏。

著录项

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号