Development of a Preliminary Weight Estimation Method for Advanced Turbofan Engines

摘要

The present work focuses on preliminary weight estimation methods that enablethe feasibility studies of novel aero engines. The key contributions can be foundin the analysis of the existing preliminary weight estimation methods, the de-velopment of a new preliminary weight estimation method and the study on thefeasibility of a Geared Turbofan (GTF) engine.In more detail, the existing preliminary weight estimation methods are exam-ined in the rst part of the thesis, aiming to de ne their suitability for currentturbofan engines, but also for future engine arrangements. For this purpose, theyare examined not only quantitatively, to verify their accuracy, but also qualita-tively to gure out if they are able to reect the key thermodynamic and designparameter variations on weight. Apart from NASA WATE no method achieveseither the required accuracy, or simulates the weight trends.Realising the need for a more accurate, robust, exible and extensible method,a new "component based" method that performs basic component design to es-timate engine weight, is devised. Its accuracy is veri ed by comparing the wholeengine weight prediction and estimated component design against the publiclyavailable data of two major turbofan engines and the weight predictions of exist-ing weight estimation methods.ATLAS, the tool based on the above method was used to estimate weight overa range of Bypass Ratio (BPR) and Turbine Entry Temperature (TET) values fora Direct Drive Turbofan (DDTF) and a GTF two spool arrangement, reachingthe following conclusions: The adjustments of Low Pressure Turbine (LPT) number of stages or geom-etry are not su cient, if high stage isentropic e ciency values are targetedat high BPR values For the examined engine model, with the given weight estimation method-ology, the weight reduction, when a gearbox is introduced at a DDTF,depends on the reduction of LPT stages, with the other components havingnegligible impact. However, it should be noted that a constant fan diameterwas assumed for both con gurations. A fan loss model and more detailedweight estimation of frames, shafts and control and accessories is requiredto verify this conclusion. The comparison of a DDTF and a GTF engine is representative only if thecycles corresponding to the installed performance optima are considered.Engines with the same thermodynamic cycle could only be compared whenthe optima cannot be reached, due to geometry restrictions.