Investigation of Forming Curved Ablative Panels from Flat Panels for Space Shuttle

摘要

The purpose of this study was to determine the feasibility of reforming flat ablative panelguration. The study indicated that if the panels could be shaped to a radius of 2.54 m (100 in.) then 88.7% of the surface area of the orbiter could be covered, and that if they could be shaped to a radius of 3.81 m (150 in.) then 77.2% of the surface could be covered. Two basic approaches were followed to determine the best method for forming the flat panels to a curved shape. The first was to determine if partially cured panels could be formed, allowing the forming heat cycle to complete the curing of the ablator. The second method was to form fully cured flat panels into the desired curvature through a secondary heat cycle. Measurements made on the panels during storage indicated that they continued to straighten out over time. This was attributed to residual stresses locked into the panels that had not been fully relaxed by the heat cycle. (Author)