Measured voltages and currents internal to closed metal cylinders due to diffusion of simulated lightning currents

摘要

One mechanism for the penetration of lightning energy into the interior of a weapon is by current diffusion through the exterior metal case. Tests were conducted in which simulated lightning currents were driven over the exteriors of similar aluminum and ferrous steel cylinders of 0.125-in wall thickness. Under conditions in which the test currents were driven asymmetrically over the exteriors of the cylinders, voltages were measured between various test points in the interior as functions of the amplitude and duration of the applied current. The maximum recorded open-circuit voltage, which occurred in the steel cylinder, was 1.7 V. On separate shots, currents flowing on a low impedance shorting conductor between the same set of test points were also measured, yielding a maximum current of 630 A, again occurring across the interior of the steel cylinder. Under symmetrical exterior drive current conditions, a maximum end-to-end internal voltage of 4.1 V was obtained, also in the steel cylinder, with a corresponding current of 480 A measured on a coaxial conductor connected between the two end plates of the cylinder. Data were acquired over a range of input current amplitudes between about 40 and 100 kA. These data provide the experimental basis for validating models that can subsequently be applied to real weapons and other objects of interest.