Evaluation of harvesting machinery for short rotation coppice willow in Denmark

摘要

During the harvesting seasons 1994-1995 and 1995-1996 several harvesting trials were carried out within the EU project on harvesting and storage of Short Rotation Crops and within a national project. During this period the following machines were investigated: Diemelstadt poplar harvester, cut and chip; Claas forage harvester with SRF header, cut and chip; Austoft sugarcane harvester, adapted to SRF, cut and chip; Bender II, cut and chip; Hvidsted Energy Allrounder, whole shoot harvester; Dansalix whole shoot harvester. In the 1994-1995 season the intention was to harvest 300 tonnes of whole shoots, chunks and chips for a storage trial. The main conclusions of the 1994-1995 harvesting season must be that harvesting willow with the existing machines in wet winters without frozen ground is very difficult. The machines will have to be developed further and special interest should be given to developing shuttle vehicles with the same flotation as the tracked harvester. Several of the problems encountered with the machines in Denmark were confirmed by the experience in the other trials. Road transportation of chips from SRF plantations is just as expensive as transporting energy chips from the forest at about Dkr 50 per tonne over 48 km. Transporting whole shoots is very expensive due to the low bulk density. Transportation of whole shoots over 48 km costs on the average Dkr 133 per tonne fresh. A very short pilot study into chipping of whole shoots from a three metre high pile indicated that this comminution with a normal forest chipper has a low productivity (8.9 tonnes fresh per work place hour) and is very expensive at Dkr 157 per tonne. This productivity can be improved by equipping the chipper with a special feeding table and better feed rollers for the SRF crop. (EG)