Diamond-like nanocomposite coatings for LIGA-fabricated nickel alloy parts.

摘要

A commercial plasma enhanced chemical vapor deposition (PECVD) technique with planetary substrate rotation was used to apply a thin (200-400 nm thick) conformal diamond-like carbon (DLC) coating (known as a diamond-like nanocomposite (DLN)) on LIGA fabricated Ni-Mn alloy parts. The PECVD technique is known to overcome the drawbacks associated with the line-of-sight nature of physical vapor deposition (PVD) and substrate heating inherent with traditional chemical vapor deposition (CVD). The purpose of the present study is to characterize the coverage, adhesion, and tribological (friction and wear) behavior of DLN coatings applied to planar and sidewall surfaces of small featured LIGA Ni-Mn fabricated parts, e.g. 280 {micro}m thick sidewalls. Friction and wear tests were performed in dry nitrogen, dry air, and air with 50% RH at Hertzian contact pressures ranging from 0.3 to 0.6 GPa. The friction coefficient of bare Ni-Mn alloy was determined to be 0.9. In contrast, low friction coefficients ({approx}0.02 in dry nitrogen and {approx}0.2 in 50% RH air) and minimal amount of wear were exhibited for the DLN coated LIGA Ni-Mn alloy parts and test coupons. This behavior was due to the ability of the coating to transfer to the rubbing counterface providing low interfacial shear at the sliding contact; resultantly, coating one surface was adequate for low friction and wear. In addition, a 30 nm thick titanium bond layer was determined to be necessary for good adhesion of DLN coating to Ni-Mn alloy substrates. Raman spectroscopy and cross-sectional SEM with energy dispersive x-ray analysis revealed that the DLN coatings deposited by the PECVD with planetary substrate rotation covered both the planar and sidewall surfaces of LIGA fabricated parts, as well as narrow holes of 300 {micro}m (0.012 inch) diameter.