Evaluation Report on CCTF CORE-I REFLOOD TEST Cl-4 (Run 13) and Cl-15 (Run 24). Investigation of the Refill Simulation and the Nitrogen Injection Effects

摘要

The tests Cl-4 and Cl-15 were performed with the Cylindrical Core Test Facility (CCTF) to investigate the effects of the depressurization process to simulate the refill phase, and the effects of the nitrogen to be injected after the end of the accumulator injection on the thermo-hydraulic behavior in the core and primary loop system during refill and reflood phases. In these tests, after the lower plenum was filled to 0.9m level with saturated water at 0.6 MPa, the accumulator water was injected into three intact cold legs in the depressurization period from 0.6 MPa to 0.2 MPa. The water in the lower plenum voided during the depressurization and the significant steam condensation occurred in or near the intact cold legs. The condensation caused high steam flow rate in the intact loops and the lower plenum flashing resulted in suppressed core water accumulation. The slightly lower core heat transfer coefficient due to the less core water caused the higher turnaround temperature and the longer quench time than those of the normal reflood test without the depressurization process. The nitrogen injection followed the accumulator injection was allowed in the test Cl-15. However, significant effects of the nitrogen injection was not observed. (Atomindex citation 15:059466)