Data and conclusions from tests on small screws.

摘要

The integrity of many mechanical assemblies and electrical components depends on small threaded fasteners. The design standards for small (less than (1/4) inch in diameter) screws made of stainless steel are not as well developed as those for larger sizes of high strength steels. The typical design approach is based on the application of static design principals. Steady state accelerations are applied to the component or assembly and sufficient screws are installed in mounting hardware for attachment to the next assembly. These design principals have been used successfully for years in a wide variety of applications. As the parts requiring small screws have continued to decrease in size, some design requirements include greater thread depths and adherence to strict interpretation of the governing thread standards. These design requirements have their origins in the lack of adequate definitions and standards for designs using small threaded fasteners. These design practices have led to significant problems in manufacturing parts with small threaded fasteners by requiring thread depths to four and more diameters of engagement while maintaining thread heights (radial engagement) of 75 percent throughout the thread interfaces. A test program was developed to address questions regarding design and manufacturing issues involving small threaded fasteners which included tensile strength, length of engagement needed to achieve the full strengths of the screws, and verification of the static design principals in dynamic conditions. This paper summarizes the initial results obtained to date from this test program and describes the work-in-progress on the dynamic tests with their related static tests. 2 refs., 4 figs., 4 tabs.