Enhancing the use of coals by gas reburning-sorbent injection. Quarterly report No. 20, July 1--September 30, 1992

摘要

The objective of this project is to evaluate and demonstrate a cost effective emission control technology for acid rain precursors, oxides of nitrogen (NO(sub x)) and sulfur (SO(sub x)) on two coal fired utility boilers in Illinois. The units selected are representative of pre-NSPS design practices: tangential and cyclone fired. Work on a third unit, wall fired, has been stopped because of funding limitations. The specific objectives are to demonstrate reductions of 60 percent in NO(sub x) and 50 percent in SO(sub x) emissions, by a combination of two developed technologies, gas reburning (GR) and sorbent injection (SI). With GR, about 80--85 percent of the coal fuel is fired in the primary combustion zone. The balance of the fuel is added downstream as natural gas to create a slightly fuel rich environment in which NO(sub x) is converted to N(sub 2). The combustion process is completed by overfire air addition. So(sub x) emissions are reduced by injecting dry sorbents (usually calcium based) into the upper furnace. The sorbents trap SO(sub x) as solid sulfates that are collected in the particulate control device. This project is conducted in three phases at each site: (1) Design and Permitting; (2) Construction and Startup; and, (3) Operation, Data Collection, Reporting and Disposition. Technology transfer to industry is accomplished through the formation of an industry panel.