Experimental Study of Turbulent Boundary Layers Subjected to High Free-Stream Turbulence Effects

摘要

The work presented in this thesis was on nominally two-dimensional turbulent boundary layers at zero pressure gradient subjected to high free-stream turbulent intensities of up to 7.9% in preparations for high free-stream turbulence studies on three-dimensional boundary layers. The two-dimensional turbulent flow that will impinge three-dimensional bodies needed to be characterized, before the three-dimensional studies can be made. An active turbulence generator designed to create high free-stream turbulence intensities in the wind tunnel was tested and modified in order to obtain the lowest possible mean flow non-uniformities. A seven-hole pressure probe was used to obtain planes of mean velocity measurements. A three-component state of the art laser-Doppler velocimeter (LDV) was used to obtain mean and fluctuating velocities. Previous high free-stream turbulence studies have been reviewed and are discussed, and some of the previously published data of other authors have been corrected. Based on the measurements obtained with the LDV, it was also determined that the semi-log law of the wall is valid for high free-stream turbulence cases, but with different constants than the ones proposed by Coles, where the constants for the high free-stream cases may be dependent on the turbulence intensity. For the first time, the skin friction coefficient CO was deduced from the viscous sublayer. The difference between the Utau obtained in the viscous sublayer mean velocity profile and the Utau obtained in the semilog layer was 1.5%. The skin friction coefficient was determined to increase by 10.5% when the two-dimensional turbulent boundary layer was subjected to high free-stream turbulence effects. Spectral data were compared to the von Karmen and Pope's model spectra; the von Karman spectrum was proven to fit slightly better. Finally the Hancoc-Bradshaw-Blair parameter agreed very well with previously published data.