...
首页> 外文期刊>Spectrochimica Acta, Part B. Atomic Spectroscopy >An X-ray fluorescence spectrometer with a pyroelectric X-ray generator and a secondary target for the determination of Cr in steel
【24h】

An X-ray fluorescence spectrometer with a pyroelectric X-ray generator and a secondary target for the determination of Cr in steel

机译:带有热电X射线发生器和次要靶标的X射线荧光光谱仪,用于测定钢中的Cr

获取原文
获取原文并翻译 | 示例

摘要

An X-ray fluorescence(XRF)setup with a pyroelectric X-ray generator and a secondary target for the determination of Cr in steel is presented.The pyroelectric X-ray generator,which can be driven by a dry battery,is a low power X-ray source and emits X-rays over a large solid angle.X-rays emitted by this generator can be effectively put to use by a disk-shaped secondary target.An appropriate arrangement of(i)X-ray generator,(ii)sample support,(iii)secondary target,and(iv)detector enables secondary X-rays to irradiate the sample from a short distance.The secondary X-rays are emitted from a wide-area secondary target.The present arrangement also enables the sample to be placed near the detector.The short distance from the sample to both the secondary target and the detector enhances signal intensity.An absolute amount of 1.3 mu g Cr can be detected by the present setup.A minimum detection limit of 0.09 wt.% Cr in steel by 1000-s measurement has been achieved.
机译:提出了一种具有热释电X射线发生器和用于测定钢中Cr的次级靶标的X射线荧光(XRF)装置。该干电池可驱动的热释电X射线发生器功率低X射线源,并以较大的立体角发射X射线。此发生器产生的X射线可被圆盘状次要靶有效地使用。(i)X射线发生器的适当布置,(ii样品支撑,(iii)次要靶标和(iv)检测器使次要X射线可以从短距离照射样品。次要X射线是从广域次要靶标发出的。样品放置在检测器附近。从样品到次要靶标和检测器的短距离增强了信号强度。通过当前设置可以检测到1.3μg铬的绝对量。最小检测限为0.09 wt。通过1000秒的测量获得了钢中的%Cr。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号