首页> 外文期刊>Shock Waves >Research on the optimum length-diameter ratio of the charge of a multimode warhead
【24h】

Research on the optimum length-diameter ratio of the charge of a multimode warhead

机译:多模战斗部装药最佳长径比研究

获取原文
获取原文并翻译 | 示例
           

摘要

This paper outlines our research on a multimode warhead in which we adopted center point and annular initiation modes to form multimode penetrators. Using LS-DYNA software, we studied the effect of the configuration parameters, namely the length/diameter ratio of the shaped charge, on the formation parameters, such as the velocity and length/diameter ratio, of multimode penetrators. We found that when the charge length was in the range of 0.9-1.2 times the charge diameter, the same structure of shaped charge can form suitable multimode penetrators. Either an explosively formed penetrator (EFP) or a long stretchy rod-shaped EFP penetrator can be formed. We establish an optimum charge length for penetrator formation of 1.4 times the charge diameter. Simulation results were validated using X-ray imaging experiments and they were in good agreement. The results found that by increasing the charge length from 0.9 to 1.4 times the charge diameter, the penetration depth of the EFP increased by 74.5%, while increasing the charge length from 1.4 to 1.6 times the charge diameter only increased the penetration depth by 1.9%.
机译:本文概述了我们对多模式弹头的研究,其中我们采用了中心点和环形起爆模式来形成多模式穿透器。使用LS-DYNA软件,我们研究了构型参数(即成形装药的长径比)对多模穿透器的形成参数(如速度和长径比)的影响。我们发现,当装药长度在装药直径的0.9-1.2倍范围内时,相同结构的聚能装药可以形成合适的多模穿透器。可以形成爆炸性的穿透器(EFP)或细长的杆状EFP穿透器。我们为穿透器的形成确定了最佳装药长度,该长度是装药直径的1.4倍。使用X射线成像实验验证了仿真结果,并且两者吻合良好。结果发现,通过将装药长度从装药直径的0.9倍增加到1.4倍,EFP的穿透深度增加了74.5%,而将装药长度从装药直径的1.4到1.6倍增加仅使穿刺深度增加了1.9% 。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号