With the temporary machining adapters Loctited in place, set up the spindle between centres. Take light cuts, use a very sharp tool and you will have no difficulty. The ball races want to be a snug sliding fit on the spindle shaft. The end of the spindle is turned down to 18mm dia. and threaded with a 1mm pitch (or any convenient thread) for a length of 40mm and should end just inside the rear ball race. Photograph 3 {M.E. 4324, 25 April 2008) shows the 50 tooth by 2.5mm pitch timing pulley and two threaded locking rings. The pulley has also been threaded with a lmm x 18mm thread.
展开▼
机译:在临时加工适配器定位到位的情况下,在中心之间设置主轴。轻切一下,使用非常锋利的工具,您将不会遇到任何困难。滚珠座圈想与主轴紧密配合。主轴末端直径减小到18mm。并以1mm的螺距(或任何方便的螺纹)拧入40mm的长度,并且应仅在后部滚珠圈内结束。照片3 {M.E. 4324,2008年4月25日)显示了50齿x 2.5mm节距同步皮带轮和两个带螺纹的锁紧环。皮带轮还带有1mm x 18mm的螺纹。
展开▼