首页> 外文期刊>Materials transactions >Influence of Post-Annealing on the Oxide Layer of AZ91 Mg Alloy Prepared by Plasma Electrolytic Oxidation
【24h】

Influence of Post-Annealing on the Oxide Layer of AZ91 Mg Alloy Prepared by Plasma Electrolytic Oxidation

机译:后退火对等离子电解氧化制备的AZ91 Mg合金氧化层的影响

获取原文
获取原文并翻译 | 示例
           

摘要

The influence of the post-annealing (PA) treatment on plasma electrolytic oxidation (PEO) treated AZ91 Mg alloy was investigated and the dependence of the dehydration reaction on the PA temperature was also studied. In this study, a series of PA treatments were carried out on the coated samples at four different temperatures, i.e. 373,423,473, and 523 K for 10 h. In contrast to the sample without PA treatment, the samples annealed at temperatures higher than 423 K exhibited a significant difference in terms of surface morphology since the MgO content in the oxide layer increased with increasing PA temperature. With increasing PA temperature, the dehydration of Mg(OH)_2 led to the increase in the relative amount of the MgO, which was a hard phase. From the nano-indentation results, the applied loads of the samples were seen to increase as PA temperatures increased. Moreover, the corrosion resistance of the sample annealed at 423 K was higher than that of the samples annealed at three different PA temperatures.
机译:研究了后退火(PA)处理对等离子电解氧化(PEO)处理的AZ91 Mg合金的影响,并且研究了脱水反应对PA温度的依赖性。在这项研究中,在四个不同的温度(即373,423,473和523 K)下,对涂层样品进行了一系列的PA处理10小时。与未进行PA处理的样品相比,在高于423 K的温度下退火的样品在表面形态方面表现出显着差异,因为随着PA温度的升高,氧化物层中的MgO含量会增加。随着PA温度的升高,Mg(OH)_2的脱水导致MgO的相对含量增加,这是一个硬相。从纳米压痕结果可以看出,样品的施加载荷随着PA温度的升高而增加。此外,在423 K下退火的样品的耐腐蚀性高于在三个不同PA温度下退火的样品的耐腐蚀性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号