A modified solution to assess the required strength of exposed backfill in mine stopes

摘要

Backfilling contributes to the improvement of ground stability and reduction of ore dilution in underground mines. A critical issue for backfilled stope design is the required strength for the fill material. A practical solution to address this question was proposed by Mitchell and co-workers for stopes with an exposed face and a high aspect ratio (height H over width B). However, this solution is not directly applicable to stopes with a relatively low aspect ratio (H/B). Its application is also restricted by additional limitations on the strength along the fill-rock interfaces and the load applied on top of the backfill. In this note, the model proposed by Mitchell and co-workers is modified to provide an estimate of the required strength of backfill for various geometries, material properties, and surface loads. The modified Mitchell (MM) solution is validated against experimental results. Sample calculations with the MM solution are also presented and discussed.