Mechanical properties of curved composite box girders with corrugated steel webs

摘要

Several methods derived for use on traditional concrete curved box girders (CBGs) are used in design practice. However, these typically consider only one elastic modulus and one shear modulus, and consequently cannot be applied directly to CBGs with corrugated steel webs (CSWs) due to the large shear deformations and small longitudinal stiffness of CSWs, while these shear deformations are small and usually ignored for common concrete webs. In this paper, firstly, the flexure-torsion governing differential equations considering the shear deformations and the accordion effect of CSWs, and the distortion governing differential equation considering the accordion effect of CSWs are derived for CBGs with CSWs. A practical method which can solve the deflections, torsional angles, distortional angles, stresses and internal forces of simple and continuous CBGs with intermediate diaphragms is proposed. Secondly, the results of a series of tests performed on three CBGs with CSWs, published test results, as well as finite element analysis results and theoretical results of straight box girders (SBGs) with CSWs are used to verify the correctness of the analytical method. The agreement between analytical, experimental and numerical results is good. Finally, a parametric analysis is conducted and the results show that: (a) the influence of shear deformations of CSWs on the deflections of CBGs with CSWs increases with increasing curvature radius R. For SBGs with CSWs, the deflections may increase by 30 when considering shear deformations. For CBGs with CSWs, the deflection increase ranges between 8 and 30 for concentrated loads depending on the curvature radius. (b) the distortional shear stress, which is small and typically neglected for CBGs with concrete webs, may be as big as, or larger than the flexural shear stress, and must be considered. The restrained torsional shear stress, which is also small and typically neglected for CBGs with concrete webs, can reach 9 of the flexural shear stress, and also must be considered.