The location of a resistive shunt harmonic impedance along a distribution feeder and its influence on harmonic propagation

摘要

Although complete compensation is only possible using true active filters, resistive shunt harmonic impedances (SHI) have been shown to provide a considerable reduction of the harmonic propagation. In this paper, the harmonic mitigation potential of a resistive SHI is discussed concerning its influence on the voltage distortion profile along a typical distribution feeder, with the location of the SHI along the feeder as a parameter. Although the distortion values are dependent on the SHI location, it is shown that the end of the feeder is generally a good location to install the SHI, especially when the power system parameters can vary or are unknown. Calculations are performed on a typical radial distribution feeder. Both the power factor correction capacitors and the non-linear loads are concentrated in single nodes. The linear loads are disconnected to obtain the worst case for the voltage distortion. Also some measurements on a scale model of a typical distribution feeder are done and the experimental results confirm the results obtained from simulations.