Numerical modeling of grade mixing and inclusion entrapment in eight strand billet tundish

摘要

This study aims to investigate the effect of tundish level control on the change in element content and inclusion amount in molten steel during the low tundish-level steel grade transition. Based on multiphase flow, mass transfer, and discrete phase, a three-dimensional transient numerical simulation of the tundish was established in Ansys Fluent. The model uses moving mesh refinement technology to obtain clear steel and slag interface with a small number of meshes. The numerical simulation results were verified through industrial experiments and physical simulations. The results indicate that when the tundish is at a low level, strand 3 becomes a short-circuit flow, and the number of inclusions in strand 3 is approximately four times that in strand 1. If the old grade density is higher than that of the new grade, the unqualified length of the element content in the transition billet is 10.2?m shorter than that in the opposite order. When the filling speed of the tundish is three times the normal flow rate, the length of the transition billet with an unqualified number of inclusions is 7.1?m less than that when the filling speed is 2 times the normal flow rate. In addition, at the initial stage of the low tundish level steel grade transition, the minimum amount of inclusions in the transition billet can be reduced to 40 of the average amount of inclusions in the old grade; however, the maximum number of inclusions in the transition billet increase by a factor of 2.5 times the average number of inclusions in the new grade at the end stage of the low tundish-level steel grade transition. It can be observed that the inclusions in the initial stage of the low tundish-level steel grade transition have less effect on the quality of the old grades; however, they have a greater effect on the new grades in the final stage of the low tundish-level steel grade transition.