首页> 外文期刊>Atmospheric chemistry and physics >Optical and microphysical characterization of aerosol layers over South Africa by means of multi-wavelength depolarization and Raman lidar measurements
【24h】

Optical and microphysical characterization of aerosol layers over South Africa by means of multi-wavelength depolarization and Raman lidar measurements

机译:通过多波长去极化和拉曼激光雷达测量,对南非上空的气溶胶层进行光学和微物理表征

获取原文
获取原文并翻译 | 示例
           

摘要

Optical and microphysical properties of different aerosol types over South Africa measured with a multi-wavelength polarization Raman lidar are presented. This study could assist in bridging existing gaps relating to aerosol properties over South Africa, since limited long-term data of this type are available for this region. The observations were performed under the framework of the EUCAARI campaign in Elandsfontein. The multi-wavelength Polly(XT) Raman lidar system was used to determine vertical profiles of the aerosol optical properties, i.e. extinction and backscatter coefficients, Angstrom exponents, lidar ratio and depolarization ratio. The mean microphysical aerosol properties, i.e. effective radius and single-scattering albedo, were retrieved with an advanced inversion algorithm. Clear differences were observed for the intensive optical properties of atmospheric layers of biomass burning and urban/industrial aerosols. Our results reveal a wide range of optical and microphysical parameters for biomass burning aerosols. This indicates probable mixing of biomass burning aerosols with desert dust particles, as well as the possible continuous influence of urban/industrial aerosol load in the region. The lidar ratio at 355 nm, the lidar ratio at 532 nm, the linear particle depolarization ratio at 355 nm and the extinction-related Angstrom exponent from 355 to 532 nm were 52 +/- 7 sr, 41 +/- 13 sr, 0.9 +/- 0.4% and 2.3 +/- 0.5, respectively, for urban/industrial aerosols, while these values were 92 +/- 10 sr, 75 +/- 14 sr, 3.2 +/- 1.3% and 1.7 +/- 0.3, respectively, for biomass burning aerosol layers. Biomass burning particles are larger and slightly less absorbing compared to urban/industrial aerosols. The particle effective radius were found to be 0.10 +/- 0.03, 0.17 +/- 0.04 and 0.13 +/- 0.03 mu m for urban/industrial, biomass burning, and mixed aerosols, respectively, while the single-scattering albedo at 532 nm was 0.87 +/- 0.06, 0.90 +/- 0.06, and 0.88 +/- 0.07 (at 532 nm), respectively, for these three types of aerosols. Our results were within the same range of previously reported values.
机译:介绍了使用多波长偏振拉曼激光雷达测量的南非不同气溶胶类型的光学和微物理性质。这项研究可能有助于弥合南非现有与气溶胶特性有关的差距,因为该地区的此类长期数据有限。观察是在伊兰兹方丹的EUCAARI运动的框架下进行的。多波长Polly(XT)拉曼激光雷达系统用于确定气溶胶光学特性的垂直剖面,即消光和后向散射系数,埃指数,激光雷达比和去极化比。平均微物理气溶胶特性,即有效半径和单散射反照率,通过先进的反演算法获得。对于生物质燃烧和城市/工业气溶胶的大气层的强烈光学特性,观察到明显差异。我们的结果揭示了用于燃烧生物质气溶胶的广泛的光学和微物理参数。这表明生物质燃烧气溶胶可能与沙漠尘埃颗粒混合,以及该地区城市/工业气溶胶负荷的持续影响。 355 nm的激光雷达比,532 nm的激光雷达比,355 nm的线性粒子去极化比以及355至532 nm的与消光有关的埃斯特罗姆指数分别为52 +/- 7 sr,41 +/- 13 sr,0.9城市/工业气溶胶分别为+/- 0.4%和2.3 +/- 0.5,而这些值分别为92 +/- 10 sr,75 +/- 14 sr,3.2 +/- 1.3%和1.7 +/- 0.3分别用于燃烧生物质的气溶胶层。与城市/工业气溶胶相比,生物质燃烧颗粒更大,吸收更少。对于城市/工业,生物质燃烧和混合气溶胶,颗粒有效半径分别为0.10 +/- 0.03、0.17 +/- 0.04和0.13 +/- 0.03μm,而单散射反照率在532 nm处对于这三种类型的气溶胶,其分别为0.87 +/- 0.06、0.90 +/- 0.06和0.88 +/- 0.07(在532 nm处)。我们的结果在先前报告的值的相同范围内。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号