首页> 外文期刊>Applied thermal engineering: Design, processes, equipment, economics >Research on varying condition characteristic of feedwater heater considering liquid level
【24h】

Research on varying condition characteristic of feedwater heater considering liquid level

机译:考虑液位的给水加热器变化工况特性研究

获取原文
获取原文并翻译 | 示例
           

摘要

In this paper, a mathematical model of varying condition is established for the three-section heater based on dimensional analysis, then with the combination of the derivation of heat transfer coefficient in the drain cooler section, the model of operating characteristic for the heater at low liquid level is proposed. Taking #1 high pressure feedwater heater of a 330 MW turbine as example, the terminal temperature difference at both normal liquid level and low liquid level and the change of the heat transfer condition in the drain cooler section at low liquid level can be calculated respectively by the proposed model. By comparison with the test data the accuracy of the model is verified. In addition, the influence of liquid level and load on terminal temperature difference is analyzed quantitatively, and the secure liquid level and economic liquid level are reset. The results show that the study can provide a reference for the timely adjustment of the liquid level in actual operation.
机译:本文基于尺寸分析,建立了三段式加热器变化条件的数学模型,然后结合排水冷却器段中传热系数的推导,得出了低段加热器的工作特性模型。建议液位。以330 MW汽轮机的#1高压给水加热器为例,可以分别通过以下公式计算正常液位和低液位下的终端温度差以及低液位下的排水冷却器部分的传热条件变化:建议的模型。通过与测试数据进行比较,可以验证模型的准确性。此外,定量分析了液位和负荷对终端温差的影响,并重置了安全液位和经济液位。结果表明,该研究可为实际操作中及时调整液位提供参考。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号