Sampling and analysis of airborne particulate matter and aerosols usingin-needle trap and SPME fiber devices

摘要

A needle trap device (NTD) and commercial poly(dimethylsiloxane) (PDMS) 7-mum film thickness solid-phase microextraction (SPME) fibers were used for the sampling and analysis of aerosols and airborne particulate matter (PM) from an inhaler-administered drag, spray insect repellant, and tailpipe diesel exhaust. The NTD consisted of a 0.53-mm o.d. stainless steel needle having 5 mm of quartz wool packing section near the needle tip. Samples were collected by drawing air across the NTD with a Luer-tip syringe or via direct exposure of the SPME fiber. The mass loading of PM was varied by adjusting the volume of air pulled through the NTD or by varying the sampling time for the SPME fiber. The air volumes ranged from 0.1 to 50 mt, and sampling times varied from 10 s to 16 min; Particulates were either trapped on the needle packing or sorbed onto the SPME fiber, The devices were introduced to a chromatograph/mass spectrometer (GC/MS) injector for 5 min desorption, In the case of the NTD, 10 muL of clean air was delivered by a gas-tight syringe to aid the introduction of desorbed analytes. The compounds sorbed onto particles extracted by the SPME fiber or trapped in the needle device were desorbed in the injector and no carry-over was observed, Both devices performed well in extracting airborne polycyclic aromatic hydrocarbons: (PAHs) in diesel exhaust, triamcinolone acetonide in a dose of asthma drug and BEET in a dose of insect repellant spray, Results suggest that the NTDs and PDMS 7-mum fibers can be used for airborne particulate sampling and analysis, providing a simple, fast, reusable, and cost-effective screening tool, The advantage of the SPME fiber is the open-bed geometry allowing spectroscopic investigations of particulates; for example, with Raman microspectroscopy.